Pioneer S-FCRW240W-S Manuel d'utilisation - Page 5
Parcourez en ligne ou téléchargez le pdf Manuel d'utilisation pour {nom_de_la_catégorie} Pioneer S-FCRW240W-S. Pioneer S-FCRW240W-S 8 pages. Home theater loudspeaker system
Imprimer la page
OPERATING YOUR SYSTEM
Turn on your receiver with the level control initially at zero.
IMPORTANT:
Follow the instructions for your receiver and set the speakers
to SMALL in the 5.1 mode (Dolby Digital). This will ensure
that any bass signals are re-directed to the subwoofer where
they will be optimally reproduced. If you have a choice, set
the crossover frequency to 150Hz.
Now gradually increase the volume until you reach a com-
fortable listening level.
CAUTION:
The speakers are equipped with a protection device to protect
the transducers from extreme conditions. Under these
conditions the protection device will activate and stop the
speaker from producing sound. If this happens shut off the
system for 5-10 minutes and allow the protection device to
reset.
SUBWOOFER REAR SECTION
1 3
LINE LEVEL
IN
POWER
INDICATOR
1 POWER INDICATOR
Illuminates RED when the power is being supplied.
2 VOLUME LEVEL
Volume of subwoofer is adjusted with this knob. Turn this knob
clockwise to raise the level.
• Starting with "MIN", turn this knob and raise the volume
slowly. If the unit is turned on with the volume set too high, it
could cause hearing and/or speaker damage. Do not turn
the volume up excessively high. The low frequency sound
is apt to be raised too high since it is less disturbing and
harder to detect than high frequencies. Caution must be
taken here since the amplifier and speaker will be clipped
when the output of the amplifier or receiver is increased
with the subwoofer level set to "MAX".
3 LINE LEVEL IN
Connect SUBWOOFER OUTPUT terminal of the receiver to
this terminal with the supplied RCA cable.
2
VOLUME
LEVEL
MIN
MAX
CABINET MAINTENANCE
Use a polishing cloth or dry cloth to wipe off dust and dirt.
When the cabinet is very dirty, clean with a soft cloth dipped in
some neutral cleanser diluted five or six times with water, and
then wipe again with a dry cloth. Do not use furniture wax or
cleaners.
Never use thinners, benzine, insecticide sprays and other
chemicals on or near the cabinets, since these will corrode
the surfaces.
WARNING:
UNPLUG THE POWERED
SUBWOOFER BEFORE CLEANING TO REDUCE
THE RISK OF ELECTRIC SHOCK
NON SKID PADS
If the front and center speakers are placed on a hard surface, such
as wood or tile place four non skid pads on the bottom surface of
the speakers.
If the subwoofer is placed on a hard floor, such as wood or tile,
place four non skid pads on the bottom surface of the
subwoofer.
www.pioneerelectronics.com
5