Aeotec Door Window Sensor Gen5 Manuel de l'utilisateur - Page 4
Parcourez en ligne ou téléchargez le pdf Manuel de l'utilisateur pour {nom_de_la_catégorie} Aeotec Door Window Sensor Gen5. Aeotec Door Window Sensor Gen5 7 pages.
Imprimer la page
If you are using double-sided tape, wipe the two surfaces clean of any oil or dust with a damp towel. When the
surface has completely dried, peel one side of the tape back and attach it to the corresponding section on the rear
side of the mounting plates.
Adding your Sensor to your Z-Wave network.
With your mounting plates prepared to hold each component of your sensor, it's time to add it to your Z-Wave network.
1. Let your Z-Wave primary controller/gateway enter into adding/inclusion mode.
2. Take your Sensor near to your primary controller.
3. Press the Action Button once on your Sensor.
4. If your Door Window Sensor has been successfully added to your Z-Wave network, its Status LED will fast blink
for 2 seconds and then be solid for 2 seconds when you press the Action Button again. If the adding was
unsuccessful and the Status LED continues to fast blink for 8 seconds and then slow blink for 3 seconds, repeat
the above steps.
With your Door Window Sensor now working as a part of your smart home, you'll be able to configure it from your home
control software or phone application. Please refer to your software's user guide for precise instructions on configuring