Aeotec Z-Wave MultiSensor 6 Manuel de l'utilisateur - Page 9

Parcourez en ligne ou téléchargez le pdf Manuel de l'utilisateur pour {nom_de_la_catégorie} Aeotec Z-Wave MultiSensor 6. Aeotec Z-Wave MultiSensor 6 10 pages. Motion sensor. humidity sensor. thermometer. light sensor.

Imprimer la page

16-08-13

Troubleshooting

If the MultiSensor was successfully removed from the Z-Wave

network, pressing the Z-Wave button will cause the LED to

blink. If the MultiSensor was not successfully removed from

the Z-Wave network the LED will stay solid for a few

seconds.

Monitoring Motion.

The MultiSensor can send Basic Set Command to

association group 1, which is setup via the Association

Command Class, when the MultiSensor detects motion to

control the associated devices to "OPEN" state. After 4

minutes by default, if the Motion Sensor is not triggered

again, the MultiSensor will send Basic Set Command to

these devices to control them to "CLOSE" state, but if the

Motion Sensor is triggered again in 4 minutes, the

MultiSensor will reset the timing, and start to timing again.

The 4 minutes delay time can be changed through the usage

of Z-Wave command built into Z-Wave certified

controllers/gateways. The specific Z-Wave command

supporting this function is Configuration Command Class.

Please consult the operation manual for these controllers /

gateways for specific instructions on setting the Multisensor.

aeotec.com/z-wave-sensor/47-multisensor-manual.html

MultiSensor Manual - Aeotec

9/10