Dinhhai TFS Mode d'emploi

Parcourez en ligne ou téléchargez le pdf Mode d'emploi pour {nom_de_la_catégorie} Dinhhai TFS. Dinhhai TFS 2 pages. Telephone remote switch

Imprimer la page

Operating Instructions for the Telephone Remote Switch TFS

manual

switching

The Telephone Remote Switch is capable of

remotely controlling heating regulators or room

thermostats which have an appropriate entry

port. The devices switch from reduced mode

(

) to heating mode (

), as soon as the

respective terminals detect a short circuit (see

heating regulator's instructions).

1. Connection

E All devices which are connected to the

telephone network must be in accordance

with the respective prevailing national

regulations.

Contents

•

Telephone Remote Switch TFS

•

Power plug

•

Connecting cable

1. Install the TFS on a wall close to the

telephone jack

2. Connect the "Line" slot on the TFS with the

slot for additional devices on your

telephone jack. For this use the enclosed

connecting cable and the appropriate

adapter plug.

3. Connect the exit terminals (1 to 4) with the

appropriate terminals on your heating

regulator/thermostat.

1.1 Regulator-/Thermostat connection

To connect the regulator or thermostat please

follow the respective operating instructions.

Regulator

TFS

2. Switching by telephone

It is possible to switch the status of the exit

relay (and thus the type of operation at the

connected regulator/thermostat) either by

telephone or by pressing the key "manual

switching" on the TFS.

9V AC

Line

Heating D

Operation according to

program switch position

In both cases, an LED below the key shows

that the TFS is in the "heating" mode (the relay

contact is closed).

Default setting is that the TFS accepts a call

after 4 rings and expects the access code

"1234". These settings can be altered, see 2.4

and 2.5.

Please note that the TFS breaks off the

telephone connection automatically after

30 sec. if no entries are made in this time.

2.1 Entering the access code

The TFS expects 4 rings

(Changing the number of rings

see 2.5)

Dial your

telephone number

Beep Beep

Beeep

Enter the 4-digit

Code number (1 2 3 4)

To change the code No. see 2.4

2.2 Status request

Beeep

Beep-Beep

Press "1", "2", "3" or "4" to select the respective exit port

and to check the current switch position of this port

2.3 Changing the status

Beeep

Beep-Beep

Press "∗" to change the switch position

of the exit port selected in 2.2

2.4 Changing the access code

Press "# 8"

Enter your new

4-digit access code

Beep-Beep

Beeep

To confirm, please enter

your code again.

2.5 Number of rings until pick-up

Beep-Beep

Press "# 9"

Beep Beep

TFS picks up

Code ok

Code incorrect

Automatic

Heating

Automatic

Heating

Beep-Beep

Your new code number

has been accepted

Code incorrect

please start again with

Beepx

number

Enter the desired number

of rings (1-9) until the

TFS picks up