Aeotec AEOEZW111 Manuel - Page 3

Parcourez en ligne ou téléchargez le pdf Manuel pour {nom_de_la_catégorie} Aeotec AEOEZW111. Aeotec AEOEZW111 10 pages.

Since the S1 port and S2 port can be used to control the load separately, you can choose to connect the SPDT switches to the S1 or S2.

Inclusion/Exclusion

On factory default the device does not belong to any Z-Wave network. The device needs to be added to an existing wireless network to communicate with the

devices of this network. This process is called Inclusion.

Devices can also be removed from a network. This process is called Exclusion. Both processes are initiated by the primary controller of the Z-Wave network. This

controller is turned into exclusion respective inclusion mode. Inclusion and Exclusion is then performed doing a special manual action right on the device.

Inclusion

1. Install the device according to the instructions.

2. Press the button 2 times within 1 second on the Nano Dimmer.

Exclusion

1. Press the button once on the Nano Dimmer.

Quick trouble shooting

Here are a few hints for network installation if things dont work as expected.

1. Make sure a device is in factory reset state before including. In doubt exclude before include.

2. If inclusion still fails, check if both devices use the same frequency.

3. Remove all dead devices from associations. Otherwise you will see severe delays.

4. Never use sleeping battery devices without a central controller.

5. Dont poll FLIRS devices.

6. Make sure to have enough mains powered device to beneﬁt from the meshing

Association - one device controls an other device

Z-Wave devices control other Z-Wave devices. The relationship between one device controlling another device is called association. In order to control a different

device, the controlling device needs to maintain a list of devices that will receive controlling commands. These lists are called association groups and they are always

related to certain events (e.g. button pressed, sensor triggers, ...). In case the event happens all devices stored in the respective association group will receive the

same wireless command wireless command, typically a 'Basic Set' Command.

Association Groups:

Group Number

Conﬁguration Parameters

Z-Wave products are supposed to work out of the box after inclusion, however certain conﬁguration can adapt the function better to user needs or unlock further

http://manual.zwave.eu/backend/make.php?lang=en&sku=AEOEZW111

Maximum

Description

Nodes

Z-Wave Plus Lifeline.When the load state of Nano Dimmer (on/off/dim the load ) is changed, the Hail

CC, Switch Multilevel Report and Basic Report (conﬁgured by parameter 80) can be sent to the

associated nodes in this group.

Forward the Basic Set, Switch Binary Set, Switch Multilevel Start Level Change, Switch Multilevel Stop

Level Change, Switch Multilevel Set, Switch all to the associated nodes in Group 2 when the Nano

Dimmer receives the Basic Set, Switch Binary Set, Switch Multilevel Start Level Change, Switch

Multilevel Stop Level Change, Switch Multilevel Set, Switch all commands from main controller.

Send Basic Set (conﬁgured by parameter 0x51 ) to the associated nodes in Group 3 when the external

switch S1 is operated

Send Basic Set (conﬁgured by parameter 0x52) to the associated nodes in Group 4 when the external

switch S2 is operated

30-09-2020 12:35

Pagina 3 van 10