Cal Power APT 7000 Series Manuel de démarrage rapide - Page 5

Parcourez en ligne ou téléchargez le pdf Manuel de démarrage rapide pour {nom_de_la_catégorie} Cal Power APT 7000 Series. Cal Power APT 7000 Series 8 pages. Automated ac power sources

Imprimer la page

TESTSETUP

SETTING UP A TEST IN MANUAL MODE:

When the AUTO RUN parameter in the System Parameters menu is set to MANUAL

Mode and you are in the set screen the display will be as follows: (See Figure 1)

(Figure 1. Set Screen)

To initialize the test, press the Test/Reset key and the LED for the key will illuminate.

The text "Set" on the set screen will turn to Dwell. In addition, your soft keys will

change to include Meter, AUTO, Keypad, and Trig (see figure 2). In MANUAL

Mode, output will run continuously until the Test/Reset key is pressed again or there

is a failure condition.

(Figure 2. Set Screen)

In MANUAL Mode, the Rotary Knob on the front panel also becomes active. It can

be used to adjust voltage or frequency. When the instrument is in an idle state, it

can also be used to edit the Hi-Lmt. To adjust the frequency with the Rotary Knob

the meter selection must be on F. To adjust the voltage with the Rotary Knob the

meter can be on any selection except F. To adjust the Hi-Lmt with the Rotary Knob

the meter selection must be on Hi-Lmt. To adjust the output, rotate the knob either

clockwise or counterclockwise. Clockwise rotations will increase the output, whereas

counterclockwise rotations will decrease the output. If LOCK is set to ON, the Rotary

Knob is disabled.