Ariston PC 640 TX AUS Manuel d'utilisation - Page 14

Parcourez en ligne ou téléchargez le pdf Manuel d'utilisation pour {nom_de_la_catégorie} Ariston PC 640 TX AUS. Ariston PC 640 TX AUS 32 pages.

detergents containing phosphorus. After cleaning, rinse

AUS

and dry any remaining drops of water.

! It is not necessary to remove the pan supports in order to

clean the hob surface. Thanks to the support system, simply

lift and hold the pan supports or rotate them until they rest

against a rear support.

Do not place the hot grids on top of the glass cover (if

applicable), otherwise the rubber plugs on the glass

may be damaged.

Gas tap maintenance

Over time, the taps may become jammed or difficult to turn.

If this happens, the tap must be replaced.

! This procedure must be performed by a qualified

technician authorised by the manufacturer.

Troubleshooting

It may happen that the appliance does not function properly

or at all. Before calling the service centre for assistance,

check if anything can be done. First, check to see that there

are no interruptions in the gas and electrical supplies, and,

in particular, that the gas valves for the mains are open.

The burner does not light or the flame is not even

around the burner.

Check whether:

• The gas holes on the burner are clogged.

• All the movable parts that make up the burner are

mounted correctly.

• There are draughts near the appliance.

The flame dies in models with a safety device.

Check to make sure that:

• You pressed the knob all the way in.

• You keep the knob pressed in long enough to activate

the safety device.

• The gas holes are not blocked in the area corresponding

to the safety device.

The burner does not remain lit when set to minimum.

Check to make sure that:

• The gas holes are not blocked.

• There are no draughts near the appliance.

• The minimum setting has been adjusted properly.

The cookware is unstable.

Check to make sure that:

• The bottom of the cookware is perfectly flat.

• The cookware is positioned correctly at the centre of the

burner.

• The pan support grids have been positioned correctly.