Whirlpool 220-240~volt Manuel d'instructions pour l'installation et l'utilisation - Page 5

Parcourez en ligne ou téléchargez le pdf Manuel d'instructions pour l'installation et l'utilisation pour {nom_de_la_catégorie} Whirlpool 220-240~volt. Whirlpool 220-240~volt 18 pages. Whirlpool washer lnstallation instructions 220/240-volt, 60-hz models
Également pour Whirlpool 220-240~volt : Instructions d'installation (5 pages)

Imprimer la page
Tools and materials needed for
installation:
8 mm boxend
u
Pliers
Wes
.('i
Power inlet'
- Cable clip
Now start
With compactor
in room where it will be installed.
Do not grasp console
to move compactor.
Slide compactor
onto cardboard
or hardboard
before moving
compactor
across floor to prevent
damaging
floor covering.
Do not allow the rear frame of compactor
to
touch the floor covering
when lifting
or moving
compactor.
1. Remove compactor from shipping carton. Remove
all protective packaging materials such as tape and
shipping pads. Remove waxy residue caused by
protective shipping material with a mild solution of
liquid household cleaner and water.
2. Plug in power cord to compactor power inlet on the
back panel. Power cord may be attached to cable clip.
3. Place two corner posts from carton on floor near
compactor. Open compactor drawer and remove
any shipping materials or other items shipped in
the drawer. Do not remove the compactor bag
(if installed). Grasp the handle and raise the front of
the drawer until it clears stops. Grasp sides of drawer
and lift drawer out of compactor. Place the drawer on
the two corner posts.
IMPORTANT:
Use proper lifting methods in order to
avoid injury.