Whirlpool 7MWFC5090KC Manuel d'utilisation et d'entretien et instructions d'installation - Page 19

Parcourez en ligne ou téléchargez le pdf Manuel d'utilisation et d'entretien et instructions d'installation pour {nom_de_la_catégorie} Whirlpool 7MWFC5090KC. Whirlpool 7MWFC5090KC 40 pages. Smart all-in-one washer and dryer

Whirlpool 7MWFC5090KC Manuel d'utilisation et d'entretien et instructions d'installation

INSTALLATION INSTRUCTIONS

Location Requirements

Proper installation is your responsibility. Check code
requirements. Some codes limit, or do not permit, installing
Washer/Dryer in garages, closets, mobile homes, or sleeping
quarters. Contact your local building inspector.
You will need:
A separate 20 A circuit.
n
A grounded electrical outlet located no more than 2 feet
n
(610 mm) from either side of the dryer. See "Electrical
Requirements."
Only cold water tap located no more than 4 feet (1.2 m) from
n
the cold water fill valve on the washer and a water pressure of
3-116 psi (20- 800 kPa).
A level floor with a maximum slope of 1 "(25 mm) under the full
n
washer. Installation on carpets or foam-backed surfaces is not
recommended.
The floor must support the total weight of the washer (with
n
water and load) of 400 lbs (180 kg).
To install in your garage, place the dryer at least 18 "(460 mm)
n
above the floor.
IMPORTANT: do not install, store or operate the Washer/Dryer
where it will be exposed to the weather or temperatures below 32
° F (0 ° C). Water remaining in washer/dryer after use may cause
damage in low temperatures. See " Smart All-In-One Washer/
Dryer Maintenance" for winterizing information.
33¼" Mín.
(845 mm)
333⁄4" Máx.
(857 mm)
25"
(630 mm)
All dimensions show recommended spacing allowed, except for
closet door ventilation openings which are the minimum required.
For each arrangement, consider allowing more space for ease of
installation and servicing, and spacing for companion appliances
and clearances for walls, doors, and floor moldings.
Space must be large enough to allow door to fully open. Add
spacing of 1" (25 mm) on all sides of washer/dryer to reduce
noise transfer. If a closet door or louvered door is installed, top
and bottom air openings in door are required.
23 ¼"
(590 mm)
48
/
"
15
16
(1243 mm)
19