Ariston PH 760 RF GH Manuel de l'utilisateur - Page 4

Parcourez en ligne ou téléchargez le pdf Manuel de l'utilisateur pour {nom_de_la_catégorie} Ariston PH 760 RF GH. Ariston PH 760 RF GH 11 pages. Ariston hob

Imprimer la page

•

Lift the burner completely out of its housing;

•

Replace it in its housing in the position desired;

•

Make sure that the burners are positioned correctly

before use.

In addition, the two burners can be used in tandem or

speartely with cookware of different shapes and sizes:

•

Double burner for a fish-kettle or oval cookware (Fig. A).

•

Double burner for a griddle or rectangular/square

cookware with minimum dimensions of 28x28 cm

(Fig. B)

•

Single burner for medium size cookware (diameter of

16-20 cm) (Fig. C).

•

NEVER use the double burner in the configuration

represented in figure D.

Fig. A

Fig. C

Practical Advise on Using the Ceramic Glass Module

Set. Radiant Burner

Off

To melt butter and chocolate.

To heat liquids.

For creams and sauces.

For cooking at the boiling point.

For roasts.

For boiling large pieces of meat.

12 For frying.

For utilising both cooking areas.

Fig. B

Fig. D

For best performance, keep in mind the following:

•

All types of casseroles can be used on the ceramic

glass cooking surface. However, it is important that the

bottom be perfectly flat. Casseroles with thicker bottoms

distribute heat more evenly.

•

Use cookware the diameter of which is at least as large

as the cooking area so that all of the heat produced by

the heating element is used.

•

Make sure that the bottom of the pot is always dry and

clean to insure good contact between the cookware

and the cooking surface. This will also increase the life

of the pots and of the ceramic glass surface as well.

•

Do not use the same cookware that you use for gas

burners because the concentrated heat they produce

can deform the bottom of the pot. Therefore, you will

not achieve best results when using these pots on the

ceramic glass surface.

Notice: The glue used to seal the glass surface may leave

traces on the appliance. We recommend that the module

be cleaned with a non-abrasive cleaner before being used

the first time. During the first few hours of use, you may

detect the smell of rubber; this will disappear after a short

time.