Whirlpool AWM 9100 GH Manuel d'utilisation - Page 2
Parcourez en ligne ou téléchargez le pdf Manuel d'utilisation pour {nom_de_la_catégorie} Whirlpool AWM 9100 GH. Whirlpool AWM 9100 GH 15 pages.
Imprimer la page
BEFORE USING THE WASHING MACHINE
1.Remove the packaging and check
• After unpacking, make sure that the washing
machine is undamaged. If in doubt, do not use
the washing machine. Contact After-Sales
Service or your local dealer.
• Keep the packaging materials (plastic bags,
polystyrene parts, etc.) out of reach of children,
since it is a possible source of danger.
2.Remove the transit bolts
• The appliance is fitted with transit bolts to
prevent internal damage during transport.
Before using the washing machine you must
remove the transit bolts (see "Installation/
Remove the transit bolts").
3.Install the washing machine
• Install the appliance on a solid and level floor
surface. In the case of a yielding sub-floor, the
appliance should be installed in the corner of a
room.
• Adjust the feet to ensure that the machine is
stable and level on the floor (see "Installation/
Adjust the feet").
4.Water inlet
• Connect the water supply inlet hose in
accordance with the regulations of your local
water company (see "Installation/Connect the
water inlet hose").
• Water supply:
Cold water only
• Tap:
3/4" threaded hose connection
• Pressure:
100-1000 kPa (1-10 bar).
5.Drain hose
• Connect the drain hose to the ventilated siphon
or hook it over the edge of a sink by means of
the "U" bend (see "Installation/Connect the
water drain hose").
6.Electrical connections
• Electrical connections must be carried out by a
qualified electrician in compliance with the
manufacturer's instructions and local safety
regulations.
• Voltage information, power consumption and
electrical fusing data are supplied on the front
panel behind the door frame.
• The appliance must be connected to the mains
exclusively by means of a socket with an earth
connection in accordance with established
regulations. The appliance must be earthed by
law. The manufacturer declines all liability for
possible damage to property or injury to persons
or pets deriving from failure to observe the a/m
directions.
• Do not use extension leads or multi sockets.
• Before any maintenance on the washing
machine disconnect the power plug or switch off
the power supply.
• Access to the mains plug or to disconnection
from mains supply via a double-pole switch must
be ensured at all times following the
installation.
• Do not operate the washing machine if it has
been damaged during transport. Inform the
After-Sales Service.
• Mains cable replacement is only to be carried out
by After-Sales Service.
• The washing machine must only be used in the
household for the prescribed uses.