Whirlpool 22' TO 25' NO-FROST DESIGNERSTYLE TOP FREEZER REFRIGERATOR WITH THIRSTCRUSHERDISPENSING SYSTEM Manuel d'utilisation et d'entretien - Page 6

Parcourez en ligne ou téléchargez le pdf Manuel d'utilisation et d'entretien pour {nom_de_la_catégorie} Whirlpool 22' TO 25' NO-FROST DESIGNERSTYLE TOP FREEZER REFRIGERATOR WITH THIRSTCRUSHERDISPENSING SYSTEM. Whirlpool 22' TO 25' NO-FROST DESIGNERSTYLE TOP FREEZER REFRIGERATOR WITH THIRSTCRUSHERDISPENSING SYSTEM 26 pages. 22’ to 25’ no-frost designerstyle top freezer refrigerator with thirstcrusher dispensing system

Imprimer la page
It is important to prepare your refrigerator for use. This section tells you how to clean it, connect it to a power
source, install it, and level it.
Cleaning
your refrigerator
Removing
packaging
materials
NOTE:
Do not remove any permanent instruction
Remove tape and any inside labels (except the model
labels inside your refrigerator. Do not remove the Tech
and serial number label) before using the refrigerator.
Sheet fastened under the refrigerator at the front.
To remove any remaining
tape or label glue:
l
Rub briskly with thumb.
Cleaning
it before
use
OR
After removing all packaging materials, clean your
refrigerator before using it, if necessary.
l
Apply liquid hand-dishwashing detergent to area
before removing glue as described above. Do not use
sharp instruments, rubbing alcohol, flammable fluids,
or abrasive cleaners. These can damage the material.
See "Important Safety Instructions" on page 3.
See cleaning instructions on page 21.
Plugging
it in
Recommended
Grounding
Method
A 115 Volt, 60 Hz., AC only 15 or 20 ampere fused and
properly grounded electrical supply is required. It is
recommended that a separate circuit serving only this
appliance be provided. Use a receptacle which cannot
be turned off with a switch or pull chain. Do not use an
extension cord. See Electrical Requirements and
Grounding Instructions Sheet in your Literature
Package.
C&prong grounding
type wall receptacle
Refrigerator
power cord
Installing
it properly
1.
Allow l/z inch (1.25 cm) space on each side and at
the top of the refrigerator for ease of installation.
2. If the hinge side of the refrigerator is to be against a
wall, you might want to leave extra space so the
door can be opened wider.
3. The refrigerator can be flush against the back wall.
Leveling
it
Your refrigerator has two front leveling screws - one on
the right and one on the left. To adjust one or both of
these, follow the directions below.
Rlght to ralse;
left to lower
Use a screw-
1.
Remove base grille. (See page 19.)
2. To raise front, turn screw clockwise.
3. To lower front, turn screw counterclockwise.
4. Check with level.
drlver to adjust
5. Replace base grille. (See page 19.)
6