Whirlpool WUR50X24EM Manuel d'utilisation et d'entretien - Page 5

Parcourez en ligne ou téléchargez le pdf Manuel d'utilisation et d'entretien pour {nom_de_la_catégorie} Whirlpool WUR50X24EM. Whirlpool WUR50X24EM 32 pages. Under counter refrigerator

Imprimer la page

Unpack the Refrigerator

WARNING
Excessive Weight Hazard
Use two or more people to move and install
refrigerator.
Failure to do so can result in back or other injury.
Remove the Packaging
■
Remove tape and glue residue from surfaces before turning
on the refrigerator. Rub a small amount of liquid dish soap
over the adhesive with your fingers. Wipe with warm water
and dry.
■
Do not use sharp instruments, rubbing alcohol, flammable
fluids, or abrasive cleaners to remove tape or glue. These
products can damage the surface of your refrigerator. For
more information, see "Refrigerator Safety."
■
Dispose of/recycle all packaging materials.
When Moving Your Refrigerator:
Your refrigerator is heavy. When moving the refrigerator for
cleaning or service, be sure to cover the floor with
cardboard or hardboard to avoid floor damage. Always pull
the refrigerator straight out when moving it. Do not wiggle or
"walk" the refrigerator when trying to move it, as floor
damage could occur.
Clean Before Using
After you remove all of the package materials, clean the inside
of your refrigerator before using it. See the cleaning instructions
in "Refrigerator Care."
Important information to know about glass shelves
and covers:
Do not clean glass shelves or covers with warm water when
they are cold. Shelves and covers may break if exposed to
sudden temperature changes or impact, such as bumping.
Tempered glass is designed to shatter into many small,
pebble-size pieces. This is normal. Glass shelves and covers
are heavy. Use both hands when removing them to avoid
dropping.

Reverse Door Swing (optional)

Tools Needed: Phillips screwdriver
1. Unplug refrigerator or disconnect power.
2. Remove the screws from each side of the top of the
refrigerator cabinet and set aside.
NOTE: There are seven screws total. Do not discard.
3. Remove the hinge cover and washer and set aside.
Top View
A
A. Top of refrigerator cabinet
B. Hinge cover
C. Washer
4. Lift the door straight up and off of the bottom hinge.
5. Remove the screws fastening the bottom hinge and cover
to the bottom of the refrigerator cabinet. There are five
screws total.
6. Move the bottom hinge and cover each to the opposite side
of the bottom of the refrigerator cabinet. Completely tighten
the five screws.
Front View
A
A. Cover
B. Bottom of refrigerator cabinet
7. Remove the two screws fastening the door stop spacer
and the door stop to the bottom of the refrigerator door.
8. Move the door stop spacer and the door stop to the opposite
side and fasten with the two screws. Completely tighten
the screws.
Bottom View
A. Bottom of refrigerator door
B. Door stop spacer
C. Door stop
9. Place the washer onto the bottom hinge, then install the
refrigerator door onto the washer and hinge pin.
A
B
A. Bottom hinge washer
B. Bottom hinge
B
C
B
C
D
C. Bottom hinge
D. Washer
A
B
C
5 5 5 5 5 5 5 5 5 5 5 5