Whirlpool 27' Manuel d'instructions d'installation - Page 7

Parcourez en ligne ou téléchargez le pdf Manuel d'instructions d'installation pour {nom_de_la_catégorie} Whirlpool 27'. Whirlpool 27' 22 pages. Microwave oven and thermal oven
Également pour Whirlpool 27' : Aide à l'emploi (36 pages), Manuel d'instructions d'installation (11 pages), Manuel d'instructions d'installation (11 pages), Manuel d'instructions d'installation (48 pages), Manuel d'instructions d'installation (27 pages), Manuel d'instructions d'installation (32 pages), Manuel d'instructions d'installation (12 pages), Instructions d'installation (5 pages)

ELECTRIC DRYER POWER

HOOKUP – CANADA ONLY

It is your responsibility:

To contact a quali ed electrical installer.

To be sure that the electrical connection is adequate

and in conformance with the Canadian Electrical Code,

C22.1-latest edition and all local codes. A copy of the

above codes standard may be obtained from: Canadian

Standards Association, 178 Rexdale Blvd., Toronto, ON

M9W 1R3 CANADA.

To supply the required 4 wire, single phase, 120/240 volt,

60 Hz., AC only electrical supply on a separate 30-amp

circuit, fused on both sides of the line. A time-delay fuse or

circuit breaker is recommended. Connect to an individual

branch circuit.

This dryer is equipped with a CSA International Certi ed

Power Cord intended to be plugged into a standard 14-30R

wall receptacle. The cord is 5 ft. (1.52 m) in length. Be sure

wall receptacle is within reach of dryer's nal location.

4-wire receptacle (14-30R)

Do not use an extension cord.

If using a replacement power supply cord, it is recommended that

you use Power Supply Cord Replacement Part Number 8579325.

For further information, please reference the "Assistance or

Service" section of the "Dryer User Instructions."

GROUNDING INSTRUCTIONS

WARNING:

SAVE THESE INSTRUCTIONS

Prepare dryer for leveling legs

To avoid damaging oor, use a large at piece of cardboard

from dryer carton; place under entire back edge of dryer.

Firmly grasp dryer body (not console panel) and gently lay

dryer down on cardboard.