Whirlpool 27' Manuel d'instructions d'installation - Page 15

Parcourez en ligne ou téléchargez le pdf Manuel d'instructions d'installation pour {nom_de_la_catégorie} Whirlpool 27'. Whirlpool 27' 27 pages. Microwave oven and thermal oven
Également pour Whirlpool 27' : Aide à l'emploi (36 pages), Manuel d'instructions d'installation (11 pages), Manuel d'instructions d'installation (11 pages), Manuel d'instructions d'installation (48 pages), Manuel d'instructions d'installation (22 pages), Manuel d'instructions d'installation (32 pages), Manuel d'instructions d'installation (12 pages), Instructions d'installation (5 pages)

Connect neutral ground wire

and neutral wire

Connect neutral ground wire (E) and place

hooked end (hook facing right) of neutral

wire (white or center wire) (C) of direct

wire cable under center screw of terminal

block (B). Squeeze hooked ends together

and tighten screw.

Connect ground wire

Connect ground wire (green or bare) (F) of direct wire cable

to external ground conductor screw (A). Tighten screw.

Connect remaining wires

Place hooked ends of remaining direct wire cable wires

under outer terminal block screws (hooks facing right).

Squeeze hooked ends together and tighten screws. Finally,

reinsert tab of terminal block cover into slot of dryer rear

panel. Secure cover with hold-down screw. Now, go to

"Venting Requirements."

3-Wire Direct Wire Connection

IMPORTANT: Use where local codes permit connecting

cabinet-ground conductor to neutral wire.

Prepare your 3-wire cable for

direct connection

Direct wire cable must have 5 ft. (1.52 m) of extra length so

washer/dryer may be moved if needed.

Strip 3

insulation back 1" (25 mm). If using 3-wire cable with ground

wire, cut bare wire even with outer covering. Shape wire ends

into hooks.

Remove center screw

Remove center terminal block screw (B).

" (89 mm) of outer covering from end of cable. Strip