Whirlpool 3401011 Manuel d'utilisation et d'entretien - Page 17
Parcourez en ligne ou téléchargez le pdf Manuel d'utilisation et d'entretien pour {nom_de_la_catégorie} Whirlpool 3401011. Whirlpool 3401011 20 pages. Timed dryers
Imprimer la page
PROBLEM
Shrinking
Slow drying
Static
electricity
CHECK IF
Items are overdried
Fabric type and quality is
suitable for drying
There is a large amount of
moisture
in the load to be
dried
Cold rinse water is used
Room air temperature
is
below 45°F (7°C)
Dryer is exhausted
according
to Installation
Instructions
Lint screen is full
Exhaust duct or outside
exhaust
hood is clogged
Proper electrical
supply is
used
Load is overdried
Fabric softener
is used
Synthetics,
synthetic
blends,
permanent
press and knits are
in load
- ---------
--
CAUSES/SOLUTIONS -.--,.
Remove
items while there is still a trace
of moisture.
Some items should be
removed
while damp, then shaped and
air dried.
1
Some knits are stretched
during manufac-
turing. Washing
and drying returns them
!
to the original size. This is normal. Check
j
quality of garment
before buying. Follow
fabric care label directions
carefully.
Some items hold more moisture than
others (cottons more than polyester).
They take longer to dry. Full loads take
longer to dry than small loads of the same
fabric.
A load rinsed in cold water will take
slightly longer to dry than a warm one.
Cold rinses, however,
help save energy
and reduce wrinkling
more than warm
rinses do.
Install dryer in a room where the air
temperature
is warmer than 45°F (7°C).
Cold air increases
drying time and may
cause wrinkles
not to be removed.
Install and exhaust
your dryer according
to the Installation
Instructions
provided.
Clean lint screen before or after
each use.
Clean if needed.
Properly connect the dryer to a grounded
electrical
circuit that meets the electrical
requirements
stated in the Installation
Instructions.
Remove
items while there is still a trace
of moisture.
Use a fabric softener and follow package
directions
carefully.
Synthetics,
synthetic
blends, permanent
press and knits build up static electricity.
Use a fabric softener and be careful not
to overdry the load.
17