Whirlpool 3RLEC8600 Manuel d'utilisation et d'entretien - Page 10
Parcourez en ligne ou téléchargez le pdf Manuel d'utilisation et d'entretien pour {nom_de_la_catégorie} Whirlpool 3RLEC8600. Whirlpool 3RLEC8600 12 pages. Electric and gas dryers
Également pour Whirlpool 3RLEC8600 : Manuel d'utilisation et d'entretien (12 pages), Manuel d'instructions d'installation (8 pages), Manuel d'instructions d'installation (8 pages), Manuel d'instructions d'installation (8 pages)
Imprimer la page
Vacation care
Operate your dryer only when you are at home. If you will be on
vacation or not using your dryer for an extended period of time,
you should:
1. Disconnect power.
2. Clean lint screen. See "Cleaning the Lint Screen."
Moving care
WARNING
Electric Shock Hazard
Disconnect power before servicing.
Replace all parts and panels before operating.
Failure to do so can result in death or electric shock.
1. Disconnect power.
2. Disconnect wiring.
3. Make sure leveling legs are secure in dryer base.
4. Use masking tape to secure dryer door.
10
Vacation and Moving Care
First try the solutions suggested here and possibly avoid
the cost of a service call...
Dryer will not run
Has a household fuse blown, or has a circuit breaker
tripped?
Check that the fuse is intact and tight, or that the circuit
breaker has not tripped. Replace the fuse or reset the circuit
breaker. If the problem continues, call an electrician.
Is the correct power supply available?
Electric dryers require 220-240 volt power supply. Check with
a quali ed electrician.
Was a regular fuse used?
Use a time-delay fuse.
Is the dryer door rmly closed?
Was the Start button rmly pressed?
Unusual sounds
Has the dryer had a period of non-use?
If the dryer hasn't been used for a while, there may be a
thumping sound during the rst few minutes of operation.
Is a coin, button, or paper clip caught between the drum
and front or rear of the dryer?
Check the front and rear edges of the drum for small objects.
Clean out pockets before laundering.
Are the four legs installed, and is the dryer level front to
back and side to side?
The dryer may vibrate if not properly installed. See the
Installation Instructions.
Is the clothing knotted or balled up?
When balled up, the load will bounce, causing the dryer to
vibrate. Separate the load items and restart the dryer.
Timer does not noticeably advance
Is the dryer set to Timed or Air Dry?
The timer moves slowly and continuously for the time setting.
Is the dryer set to Automatic Drying?
The timer moves only when the clothing is mostly dry. See
"How Automatic Drying Works" in "Dryer Use."
TROUBLESHOOTING
Dryer Operation