Whirlpool 8533582 Manuel d'utilisation et d'entretien - Page 16

Parcourez en ligne ou téléchargez le pdf Manuel d'utilisation et d'entretien pour {nom_de_la_catégorie} Whirlpool 8533582. Whirlpool 8533582 24 pages. Duet electronic electric dryer

Imprimer la page

To use a Manual Cycle

Rotate the dial to select a Manual Cycle.

Press MORE TIME or LESS TIME until the desired drying time

is displayed. Tap MORE TIME or LESS TIME and the time will

change by 1-minute intervals. Press and hold MORE TIME or

LESS TIME and the time will change by 5-minute intervals.

The initial time displayed is the actual drying time.

NOTE: The More Time or Less Time feature can be used only

with Manual Cycles.

Press TEMPERATURE until the desired temperature

glows.

NOTE: Pressing the Dryness Level button will cause the triple

beep indicating that this option is not selectable. Also, a

Dryness Level is not indicated.

Press the WRINKLE SHIELD™ feature button if this

option is desired.

Press the END OF CYCLE SIGNAL button to set volume

to desired level.

Press (and hold) HOLD TO START button until dryer starts

(about 1 second).

While a Manual Cycle is running, you can change the settings

for Time, Temperature, the WRINKLE SHIELD™ feature, and

the End of Cycle Signal. Press the PAUSE/CANCEL key twice

to stop the dryer and clear the settings, allowing you to select

another cycle.

Stopping Your Dryer

To stop your dryer at any time

Press PAUSE/CANCEL twice or open the door.

Pausing or Restarting

To pause the dryer at any time

Open the door or press PAUSE/CANCEL once.

To restart the dryer

Close the door and press (and hold) HOLD TO START button until

dryer starts.

NOTE: Drying will continue from where the cycle was interrupted

if you close the door and press Start within 5 minutes. If the cycle

is interrupted for more than 5 minutes, the dryer will shut off.

Select new cycle settings before restarting the dryer.

Control Locked

This feature allows you to lock your settings to prevent

unintended use of the dryer. You can also use the Control Locked

feature to prevent unintended cycle or option changes during

dryer operation.

To enable the Control Locked feature when dryer is

running:

Press and hold the END OF CYCLE SIGNAL button for

3 seconds. The control is locked when a single beep is heard and

the Control Locked status light is on.

When the dryer is off, it is not necessary to press the Control

On button before activating the Control Locked feature.

To unlock:

Press and hold the END OF CYCLE SIGNAL button for 3 seconds

to turn this feature off.

NOTE: When the dryer is running and Control Locked is on, the

dryer can be stopped by pressing the Pause/Cancel button, but

can't be restarted until the control is unlocked.

Loading

Properly loading your dryer can lower your utility bill and prolong

the life of your garments.

Loading suggestions

Load the dryer by the amount of space items take up, not by

their weight.

Do not overload the dryer. This causes wrinkling and uneven

drying.

Super Capacity Plus Dryers

Heavy Work Clothes

4 jeans

4 workpants

4 workshirts

Towels

10 bath towels

10 hand towels

Mixed Load

3 sheets (1 king, 2 twin)

4 pillowcases

3 shirts

3 blouses

2 sweatpants

2 sweatshirts

14 washcloths

9 T-shirts

9 shorts

10 handkerchiefs