Whirlpool AWZ 3303 Manuel d'utilisation - Page 4
Parcourez en ligne ou téléchargez le pdf Manuel d'utilisation pour {nom_de_la_catégorie} Whirlpool AWZ 3303. Whirlpool AWZ 3303 9 pages. Air vent electronic
Également pour Whirlpool AWZ 3303 : Manuel de référence rapide (2 pages), Manuel d'entretien (9 pages)
Imprimer la page
PRECAUTIONS AND GENERAL
RECOMMENDATIONS
1. Packing
The packing box may be fully recycled as
confirmed by the
2. Energy saving tips
•
Always dry a full load: depending on the type of
laundry and the programme/drying time.
•
By preference use the maximum spin speed
allowed by your washing machine, since draining
the water mechanically requires less energy.
•
Do not overdry the laundry.
Clean the lint filter after every drying cycle.
•
•
Place your dryer in a room with a temperature
between 15° C and 20° C. In case of higher
temperature ventilate the room.
•
Always select the correct programme/drying time
for the load in order to obtain the desired drying
results.
•
Select the gentle option only with small loads.
•
When drying cotton, for example: dry iron dry and
cupboard dry loads together. Start with the iron dry
programme/drying time setting, remove the
laundry to be ironed at the end of that cycle and dry
the remainder of the load on the cupboard dry
setting.
3. Disposing of packaging and old appliances.
The dryer is built from reusable materials. The
dryer must be disposed of in compliance with local
waste disposal regulations.
•
Before scrapping, cut off the power cable so that
the dryer cannot be connected to the mains.
4. Child safety:
Children must not be allowed to play with the
dryer.
5. General recommendations:
•
Always set the programme/time selector knob to
the "0" position after use. This prevents the dryer
from being switched on accidentally.
•
Before cleaning or carrying out maintenance,
switch off the dryer and disconnect it from the
mains supply.
•
To clean the outside of the dryer, use a neutral
detergent and a damp cloth.
•
Do not use abrasive detergents.
12
recycling symbol.
Clean the lint filter at the end of every drying
cycle:
1. Open the door.
2. Pull the filter upwards.
3. Remove lint using a soft brush or your fingertips.
Push the filter firmly back into place.
•
•
Wipe away lint from the door seal and the door
using a damp cloth.
•
If the lint filter mesh is clogged, clean it with water
and a soft brush.
•
If necessary, the power cable may be replaced with
an identical one obtained from our After-Sales
Service. The power cable must only be replaced by
a qualified technician.
EC Declaration of Conformity
This dryer has been designed, constructed and
•
distributed in compliance with the safety
requirements of EC Directives:
• 73/23/EEC Low Voltage Directive
• 89/336/EEC EMC Directive
• 93/68/EEC CE Marking Directive.
•
The dryer must be used in the household for the
described uses.