Whirlpool Cabrio,- WED7300X Manuel d'utilisation et d'entretien - Page 18

Imprimer la page

Whirlpool Cabrio,- WED7300X Manuel d'utilisation et d'entretien

Troubleshooting

First try the solutions suggested here or visit our website at www.whirlpool.com/product_help -

If you experience

Washer not performing as expected (cont.)

Incorrect dispenser

operation

Single-dose laundry

packet not dissolving

Error Code Appears in Display

"LF" (F8E1) (too long to

fill) appears in display

F#E# code (F-type error

code) appears in display

F1E1 ACU (Appliance

control fault)

F2E3 UI/ACU mismatch

F3E1 Water level sensing

failure

F5E2 Lid lock will not

lock is lid lock failure

F5E3 Lid cannot unlock

F6E2 or F6E3

Communication Error:

UI cannot communicate

F8E6 (Lid opened)

appears in display

"drn" "dr" (F9E1) (drain

pump system problem

- long drain) appears in

display

In Canada www.whirlpool.ca for assistance and to possibly avoid a service call.

Possible Causes

Clogged dispensers or laundry

products dispensing too soon.

Liquid chlorine bleach not used in

dispenser.

Adding laundry packet incorrectly.

Washer taking too long to fill. Drain

extends more than 4.5" (114 mm) into

standpipe.

System error code.

Internal ACU failure.

ACU/UI initialization error.

Pressure sensor on ACU failure.

An item in the load may be keeping

the lid from locking.

Objects on washer lid prevent it from

unlocking.

ACU or UI synchronization error.

Washer lid left open.

Washer taking too long to drain

water. Drain extends more than

4.5" (114 mm) into standpipe.

Do not overfill dispenser. Overfilling causes immediate dispensing.

Load dispensers before starting a cycle.

It is normal for small amounts of water to be remain in dispenser

at the end of the cycle.

Homes with low water pressure may result in residual powder

in the dispenser. To avoid, select a warmer wash temperature

if possible, depending on your load.

Clean dispenser nozzle and make sure drawer is properly

seated.

Use only liquid chlorine bleach in the bleach dispenser.

Be sure laundry packet is added to washer basket before adding

clothes. Follow the manufacturer's instructions to avoid damage

to your items.

Check plumbing for correct drain hose installation. Use drain

hose form and attach securely to drainpipe or tub. Do not tape

over drain opening. See Installation Instructions.

Touch POWER to clear the code and exit cycle. Then touch

POWER, select cycle, and then touch and hold START/PAUSE

to start washer. If code appears again, call for service.

Call for service.

Check for items directly under the lid.

Remove objects, such as baskets of laundry, from top of washer.

Remove power from the washer. Let washer set for 5 minutes for

the washer to completely power down. Apply power to washer

and check for error codes. If the error code persists call for

service.

Close the lid and touch Power to clear the display. If the lid is left

open for more than 10 minutes, the cycle will reset and water in

the washer will drain.

Check plumbing for correct drain hose installation. Use drain

hose form and attach securely to drainpipe or tub. Do not tape

over drain opening.

Lower drain hose if the end is higher than 96" (2.4 m) above

the floor. Remove any clogs from drain hose. See Installation

Instructions.

Solution