Whirlpool Duet GGW9250SU0 Manuel d'utilisation et d'entretien - Page 13

Parcourez en ligne ou téléchargez le pdf Manuel d'utilisation et d'entretien pour {nom_de_la_catégorie} Whirlpool Duet GGW9250SU0. Whirlpool Duet GGW9250SU0 48 pages. Electronic gas dryer

Imprimer la page

A combination

of pipe fittings must be used to connect the

dryer to the existing gas line. Shown is a recommended

connection. Your connection may be different, according to

the supply line type, size and location.

A. _" flexible gas connector

B. _" dryerpipe

C. _" to _" pipe elbow

D. _" pipe-to-flare

adapter fitting

Open the shutoff valve in the supply line. The valve is open

when the handle is parallel to the gas pipe.

A. Closed valve

B. Open valve

Test all connections

by brushing on an approved

noncorrosive leak-detection

solution. Bubbles will show a

leak. Correct any leak found.

1. Using a 4" (10.2 cm) clamp, connect vent to exhaust outlet in

dryer. If connecting to existing vent, make sure the vent is

clean. The dryer vent must fit over the dryer exhaust outlet

and inside the exhaust hood. Make sure the vent is secured

to exhaust hood with a 4" (10.2 cm) clamp.

2. Move dryer into its final location. Do not crush or kink vent.

3. (On gas models) Check that there are no kinks in the flexible

gas line.

4. Once the exhaust vent connection is made, remove the

corner posts and cardboard.

1. Check that all parts are now installed. If there is an extra part,

go back through the steps to see which step was skipped.

2. Check that you have all of your tools.

3. Dispose of/recycle all packaging materials.

4. Check the dryer's final location. Be sure the vent is not

crushed or kinked.

5. Check that the dryer is level. See "Level Dryer."

Electdca_ Shock Hazard

Pmuginto a grounded

3 prong outlet.

Do not remove ground prong.

Do not use an adapter.

Do not use an extension

cord.

Failure to follow

these instructions

can resumt in death,

fire, or emectdcamshock.

6. Plug into a grounded 3 prong outlet. Turn on power.

7. Remove any protective film or tape remaining on the dryer.

8. Read "Dryer Use."

g. Wipe the dryer drum interior thoroughly with a damp cloth to

remove any dust.

10. Select a Timed Dry heated cycle, and start the dryer. Do not

select the Air Only Temperature setting.

If the dryer will not start, check the following:

•

Dryer is plugged into a grounded 3 prong outlet.

•

Electrical supply is connected.

•

Household fuse is intact and tight, or circuit breaker has

not tripped.

•

Dryer door is closed.

11. When the dryer has been running for 5 minutes, open the

dryer door and feel for heat. If you feel heat, cancel cycle and

close door. If you do not feel heat, turn off the dryer and

check that the gas supply line shutoff valve is open.

•

If the gas supply line shutoff valve is closed, open it, then

repeat the 5-minute test as outlined above.

•

If the gas supply line shutoff valve is open, contact a

qualified technician.