Whirlpool Duet WED9200S Manuel d'utilisation et d'entretien - Page 22
Parcourez en ligne ou téléchargez le pdf Manuel d'utilisation et d'entretien pour {nom_de_la_catégorie} Whirlpool Duet WED9200S. Whirlpool Duet WED9200S 28 pages. Electronic electric dryer
Également pour Whirlpool Duet WED9200S : Dimensions et informations sur l'installation (3 pages), Dimensions (1 pages)
Imprimer la page
To use the drying rack
Do not remove the lint screen.
1. Open dryer door.
2.
A. Front edge
Place drying rack inside dryer drum, positioning the back wire
on the ledge of the inner dryer back panel. Push down on
front edge of drying rack to secure over the lint screen.
Rack Dry
Setting
Temp.
Time*
Wool Sweaters
Timed
Low
60
Block to shape and lay flat on
Dry
the drying rack.
Stuffed toys or pillows
Timed
Low
60
Cotton or polyester fiber filled
Dry
Stuffed toys or pillows
N/A
Air Only
90
Foam rubber filled
(no heat)
Sneakers
or canvas shoes
N/A
Air Only
90
(no heat)
*(Minutes) Reset time to complete drying, if needed.
NOTE: You must remove drying rack for normal tumbling. Do not
use automatic cycles with the drying rack.
DRYERCARE
A. Dryer rack front edge
B. Dryer back panel
3. Put the wet items on top of the drying rack. Leave space
between the items so air can reach all the surfaces.
NOTE: Do not allow items to hang over the edge of the drying
rack.
4. Close the door.
5. Select a timed drying cycle and temperature,
or an air cycle
(see following chart). Items containing foam, rubber, or plastic
must be dried on a clothesline or by using the Air Only
temperature setting.
6. You must select a time by pressing the DRYTIME up or down
buttons. Reset time as needed to complete drying. Refer to
the following table.
7. Press and hold START button (about 1 second).
NOTE: Check the lint screen and remove any lint accumulated
from items dried on the drying rack.
This chart shows examples of items that can be rack dried and
the suggested cycle, temperature setting and drying time. Actual
drying time will depend on the amount of moisture items hold.
Keep dryer area clear and free from items that would obstruct the
flow of combustion
and ventilation air.
Explosion
Hazard
Keep flammable
materials
and vapors,
such as
gasoline,
away from dryer.
Place dryer at least 18 inches (46 cm) above the floor
for a garage installation.
Failure to do so can result in death, explosion,
or fire.
Every load cleaning
The lint screen is located in the door opening of the dryer. The
control panel has an indicator light to remind you to clean the lint
screen before each load. A screen blocked by lint can increase
drying time.
To clean
1. Pull the lint screen straight up. Roll lint off the screen with
your fingers. Do not rinse or wash screen to remove lint. Wet
lint is hard to remove.
J
f_
2. Push the lint screen firmly back into place.
22