Whirlpool GEQ8811PL0 Manuel d'instructions d'installation - Page 4
Parcourez en ligne ou téléchargez le pdf Manuel d'instructions d'installation pour {nom_de_la_catégorie} Whirlpool GEQ8811PL0. Whirlpool GEQ8811PL0 24 pages. 27 in. (69cm) electric dryer
Imprimer la page
Power Supply C ord
Direct Wire
Fire Hazard
Use a new UL approved
30 amp power supply
cord,
Use a UL approved
strain relief.
Disconnect
power before making emectrical connections.
Connect neutram wire (white or center wire} to center
terminal
(silver),
Ground wire (green or bare wire) must be connected
to
green ground connector.
Connect remaining
2 suppmy wires to remaining
2 terminals
(goBd).
Securemy tighten
aH electrical
connections,
FaiBure to do so can resumt in death, fire, or
emectrical shock,
1.
2.
Disconnect power.
Remove the hold-down
screw and terminal block cover.
1
2
3
4
Fire Hazard
Use 10 gauge soJid copper
wire,
Use a UL approved
strain relief.
Disconnect
power before making emectrica_ connections.
Connect
neutral wire (white or center wire) to center
terminal
(simver).
Ground wire (green or bare wire} must be connected
to
green ground
connector,
Connect
remaining
2 suppmy wires to remaining
2 terminals
(gold).
Securely
tighten
aH emectrical connections.
Failure to do so can result in death, fire, or
emectrical shock.
Assemble a 3/4in. (1.9 cm) UL approved strain relief (UL
marking on strain relief) into the hole below the terminal block
opening. Tighten strain relief screws just enough to hold the
two clamp sections together. Put power supply cord through
the strain relief. The strain relief should have a tight fit with the
dryer cabinet and be in a horizontal position.
1. Terminal block cover
2. External ground connector
3. Center, silver-colored
terminal block screw
4. Hold-down
screw
5. Neutral grounding
wire (green/yellow)
6. Hole below terminal block opening
5
6
Now complete installation following instructions for your type
of electrical connection:
4-wire (recommended)
3-wire (if 4-wire is not available)