Acom 1011 Manuel d'utilisation - Page 11

Parcourez en ligne ou téléchargez le pdf Manuel d'utilisation pour {nom_de_la_catégorie} Acom 1011. Acom 1011 19 pages. Hf linear amplifier

- G2 - when illuminated, a screen-grid overload condition exists; reduce the drive power and/or refresh

the tuning (Section 4-5) for safe operation;

- IP - when illuminated, a plate current overload condition exists; reduce the drive power and/or refresh

the tuning (Section 4-5) for safe operation;

- F – when illuminated, the amplifier automatic protection has tripped. If F is accompanied with one of

the G1, G2, or IP condition indicators, the cause of the protection trip will be evident. When F alone is

illuminated, check the keying wiring, Section 2-4(d). See Section 4-6 for details about the auto-protection

system.

4. OPERATION

Operation of the amplifier is simplified through ACOM's innovative TRI tuning aid, Auto-Operate function,

and automatic protection systems. To make full use of the amplifier's potential and to configure it to

local conditions, the following information should be read carefully.

In order to turn on the amplifier, press the power switch ON at the bottom-right corner of the front

panel. The LED indicator above the switch will glow green and the audible cooling fan will start. Following

a series of automatic self-tests, the OPER LED will begin to flash green and will continue to do so during

the 30-second warm-up period. Throughout this period, the amplifier will remain in the standby mode,

and the transceiver may continue to be used. Also during this period, the A1-A2 button may be pressed

to change antennas, i.e., between the antennas connected to the ANT1 and ANT2 terminals on the rear

panel of the amplifier. Switching between the antennas does not affect the warm-up process.

To avoid damage not covered under warranty, do not change the antenna output

during a transmission, i.e., never press the A1-A2 button when transmitting.

When you intend to have a short operating break, it is better to place the amplifier

in the standby mode rather than turning it off. Tubes life is shortened by repeatedly

turning it on and off.

A minimum 30 seconds cathode warmup time is required but 60 seconds is

recommended by the tube producer. If you are not in a hurry, wait another 30 seconds

after the green OPER LED has stopped flashing.

4-2.

The OPER button changes between two modes. When the green light above the button is illuminated, the

amplifier will remain ready to operate, even automatically returning from standby after a high-drive protection

trip. That is, after a protection trip, e.g., from an overdrive event, the amplifier will normally shift to the STBY

mode for several seconds, but it will automatically return to the OPER mode after that. This is the Auto-

Operate feature. Alternatively, the OPER button may be depressed manually to go to and remain in the

STBY mode, such as when you leave the station for a while. The green LED goes off and the Auto-Operate

function is suppressed temporarily. Pressing the OPER button again restores the Auto-Operate feature.

CAUTION

NOTE