Whirlpool WHP80250 Manuel rapide - Page 3

Parcourez en ligne ou téléchargez le pdf Manuel rapide pour {nom_de_la_catégorie} Whirlpool WHP80250. Whirlpool WHP80250 4 pages.

Imprimer la page

Quick guide

THANK YOU FOR BUYING A INDESIT PRODUCT.

CARE AND MAINTENANCE

In order to receive a more complete assistance,

please register your product on

Unplug the dryer during the cleaning and maintenance

www.indesit.eu/register

procedures.

Emptying the water tank after each cycle (see Fig. A).

Pull the container out of the dryer and and empty it into a

sink or other suitable drain, then place it back. Do not use the dryer

without having inserted the container back in place.

Cleaning the door filter after each cycle (see Fig. B).

Pull the filter out and clean it by removing the lint from the

filter surface under running water or using a vacuum cleaner. For

optimal performance, dry up all the filters before inserting them

back in place. Do not use the dryer without having reinserted the

filter in place.

Remove the door filter as described below:

1. Open the door and pull upwards.

2. Open the filter and remove lint from all its parts. Replace it

correctly.

Ensure it is completely inserted flush with the dryer seal.

Cleaning the bottom filter when the relevant indicator

turns on (see Fig. C).

Pull the filter out and remove the lint from its surface by washing

it under runing water or by using a vacuum cleaner.

However, it is advisable to clean this filter after each cycle to

optimise drying performance. Do not use the dryer without

having inserted the filter in place first.

Remove the bottom filter as described below:

1. Open the lower door.

2. Take the handle and pull the lower filter out.

3. Open the rear side of the filter and remove the lint from the

inner surface of the mesh.

4. Clean the bottom filter chamber avoiding the direct contact

with the leaves.

5. Close the rear side of the lower filter and place it back by

checking it is perfectly integrated in place.

6. Lower the filter handle and close the bottom door.

7. Make sure the air intake is free.

The filters are essential parts for drying. They are intended

to collect the lint formed during drying process. In case

of clogged filters, the air flow inside the dryer would be

seriously affected: the drying times would be longer, the

energy consumption would increase and the dryer could be

damaged. If these procedures are not carried out properly,

the dryer may not start.

PRODUCT DESCRIPTION

Water Tank

Air Intake

Bottom filter

Door filter

You can download the Safety Instructions, User Manual, Product Fiche and Energy data by:

• Visiting our website - docs.indesit.eu

• Using QR Code

• Alternatively, contact our After-sales Service (See phone number in the warranty booklet). When

contacting our After-sales Service, please state the codes provided on your product's identifi cation plate.

TRANSPORT AND HANDLING

Before using the appliance carefully read the Safety Instructions.

Never lift the dryer by holding it at the worktop.

1. Unplug the dryer.

2. Make sure that door and water tank are properly closed.

3. If the drain hose is connected to your sewage system, fix the

drain hose on the rear of the dryer again (see Installation

Power consumption

off-mode (Po) - Watts

left-on mode (Pl) - Watts

Programs

Eco Cotton *

Eco Cotton

Synthetics

*Test programme according to AS/NZS 2442.2 standard. Tested with

maximum rated load capacity and dryness level Extra Dry.

Heat Pump System

The heat pump contains fluorinated greenhouse gases,

contained in a hermetically sealed unit. This sealed unit contains

0,18 kg of the F gas R134a. GWP = 1430 (1 t CO2).

kWh

2.07

4.5

1.20

0.73

Guide).

0.50

1.00

Minutes

211

131

xxxx

xxxxxxxxxxxx