Whirlpool YWED9600TZ0 Manuel d'utilisation et d'entretien - Page 8

Parcourez en ligne ou téléchargez le pdf Manuel d'utilisation et d'entretien pour {nom_de_la_catégorie} Whirlpool YWED9600TZ0. Whirlpool YWED9600TZ0 48 pages. Electronic electric dryer

Whirlpool YWED9600TZ0 Manuel d'utilisation et d'entretien
If this is a new vent system
Vent material
Use a heavy metal vent. Do not use plastic or metal foil vent.
4" (10,2 cm) heavy metal exhaust vent and clamps must be
used, DURASAFF Mventing products are recommended,
4" (10.2cm) heavy metal exhaust vent
DURASAFE
TM
vent products can be purchased from your
dealer or by calling Whirlpool Parts and Accessories.
For
more information, see the "Assistance
or Service" section.
Rigid metal vent
For best drying performance,
rigid metal vents are
recommended.
Rigid metal vent is recommended
to avoid crushing and
kinking.
Flexible metal vent
Flexible metal vents are acceptable only if accessible for
cleaning.
Flexible metal vent must be fully extended and supported
when the dryer is in its final location.
Remove excess flexible metal vent to avoid sagging and
kinking that may result in reduced airflow and poor
performance.
Do not install flexible metal vent in enclosed walls, ceilings or
floors.
Elbows
45 ° elbows provide better airflow than 90 ° elbows.
Clamps
Good
Better
Use clamps to seal all joints.
Exhaust vent must not be connected or secured with screws
or other fastening devices that extend into the interior of the
duct. Do not use duct tape.
Clamp
Exhaust
Recommended
hood styles are shown here,
B
(10.2 cm)
A. Louvered hood style
B. Box hood style
The angled hood style shown here) is acceptable.
4"
(10.2
cm)__
An exhaust
hood should
cap the vent to keep rodents
and
insects
from entering
the home.
Exhaust
hood must be at least 12" (30.5 cm) from the ground
or any object
that may be in the path of the exhaust
(such as
flowers, rocks or bushes,
snow line, etc.).
Do not use an exhaust
hood with a magnetic
latch.
Improper venting
can cause moisture
and lint to collect
indoors, which may result in:
[] Moisture damage to woodwork,
furniture, paint, wallpaper,
carpets, etc.
[] Housecleaning
problems and health problems.
Choose
your exhaust installation type
Recommended
exhaust installations
Typical installations vent the dryer from the rear of the dryer.
Other installations are )ossible.
B
A--
A. Dryer
B. Elbow
C. Wall
D. Exhaust hood
E. Clamps
F. Rigid metal or flexible metal vent
G. Vent length necessary to connect elbows
H. Exhaust outlet