Calandra Racing Concepts Carpet Knofe Xti Manuel d'assemblage et liste des pièces - Page 5

Parcourez en ligne ou téléchargez le pdf Manuel d'assemblage et liste des pièces pour {nom_de_la_catégorie} Calandra Racing Concepts Carpet Knofe Xti. Calandra Racing Concepts Carpet Knofe Xti 16 pages.

Imprimer la page

Tweak Plates

White

Side Spring

Bag 4

4-40 x 1/4"

Flat Head

TTACH

PRING TO

OLDER

Push the spring [23] into the groove on the plastic holder [22].

Make sure that the first coil sits into the angled groove. This allows

the spring to sit flat on the bottom plate. If the spring coil is not

properly seated in the groove, the spring will sit on an angle and

make the car difficult to tweak properly.

4-40 x 3/8"

Button Head

2-56 Steel

Ballstud - Black

Assemble the Tweak Plates

1 - Use the 3/8" button head screws [24] to fasten the plastic standoffs [25] to the

graphite tweak plate [20].

2 - Slide the 1/4" button head screws [26] up through the tweak plate [20] and

tighten a red low-profile ball [11] to the screw as shown in the illustration. Make

sure to use the forward hole on the tweak plate. The body mounts will go in the

rear hole in a later step.

3 - Slide the 1/4" flat head screws [27] up through the chassis and thread into the

plastic standoffs [25].

1 - Install the black 2-56 ballstuds [28] into the graphite top plate [29]. These steel balls thread into the

graphite. Be sure to start them straight and square and turn them in slowly so they do not strip or break.

2 - Push the red ballstud [30] through the graphite top plate. Use a red locknut [9] to secure it. Attach the

assembled top plate to the Pod Plates using 3 3/16" button head screws [31].

½" Plastic

4-40 x 1/4"

Standoff

Button Head

Red Alum

Red Locknut

4-40 Ballstud

Make sure spring coil

is seated into groove

on spring holder.

Red Low-

Profile Ball

4-40 x 3/16"

Button Head