Whirlpool 36" (91.4 cm) WALL-MOUNT CANOPY RANGE HOOD Instructions d'installation et manuel d'utilisation et d'entretien - Page 4

Parcourez en ligne ou téléchargez le pdf Instructions d'installation et manuel d'utilisation et d'entretien pour {nom_de_la_catégorie} Whirlpool 36" (91.4 cm) WALL-MOUNT CANOPY RANGE HOOD. Whirlpool 36" (91.4 cm) WALL-MOUNT CANOPY RANGE HOOD 28 pages. 36" (91.4 cm) wall-mount canopy range hood

Imprimer la page

Tools and Parts

Gather the required tools and parts before starting installation.

Read and follow the safety instructions provided with any tools

listed here.

Tools needed:

■

level

drill with 1¹⁄₄" (3 cm), ³⁄₈" (9.5 mm), ⁷⁄₆₄" (2.75 mm) and

■

¹⁄₈" (3 mm) drill bits

■

pencil

■

wire stripper or utility knife

■

measuring tape or ruler

■

pliers

■

caulking gun and weatherproof caulking compound

■

duct tape

■

jig saw or keyhole saw

■

flat blade screwdriver

■

metal snips

■

Phillips screwdriver

Parts needed:

1 x ¹⁄₂" conduit

■

1 wall or roof cap

■

metal vent system

■

charcoal filter – for non-vented (recirculating)

installations only

Parts supplied:

Remove parts from packages. Check that all parts were included.

■

hood canopy assembly with ventilator, light bulbs and

transition with back draft dampers installed

■

deflector for non-vented (recirculating) installations

■

Installation Instructions and Use & Care Guide

■

filter – installed in hood canopy

■

screws and drywall anchors

■

mounting template

■

2 piece vent cover

INSTALLATION REQUIREMENTS

Location Requirements

IMPORTANT: Observe all governing codes and ordinances.

Canopy hood location should be away from strong draft areas,

such as windows, doors and strong heating vents.

Cabinet opening dimensions that are shown must be used. Given

dimensions provide minimum clearance.

Grounded electrical outlet is required. See "Electrical

Requirements" section.

The canopy hood is factory set for venting through the roof or

wall. For non-vented (recirculating) installations see "Non-vented

(recirculating) installations" in "Prepare Location" section.

All openings in ceiling and wall where canopy hood will be

installed must be sealed.

Product dimensions

⁵⁄₁₆

(28.7 cm)

1" (2.5 cm) min.*

19" (48.3 cm) max.

26"

(66.0 cm)

min.

44"

(111.8 cm)

max.

25"

(63.5 cm)

¹¹⁄₁₆

(50.0 cm)

*IMPORTANT: For non-vented (recirculating) installations, minimum dimension is

6" (15.2 cm).

³⁄₁₆

(33.5 cm)

36" (91.4 cm)