Whirlpool 36'' Freestanding Gas Range Manuel d'instructions d'installation - Page 8

Parcourez en ligne ou téléchargez le pdf Manuel d'instructions d'installation pour {nom_de_la_catégorie} Whirlpool 36'' Freestanding Gas Range. Whirlpool 36'' Freestanding Gas Range 10 pages. 30" and 36" gas sealed burner cooktop
Également pour Whirlpool 36'' Freestanding Gas Range : Manuel d'instructions d'installation (13 pages), Manuel d'instructions d'installation (7 pages), Manuel d'instructions d'installation (7 pages), Instructions d'installation et manuel d'utilisation et d'entretien (28 pages), Manuel d'instructions d'installation (28 pages), Manuel d'instructions d'installation (6 pages), Manuel d'instructions d'installation (7 pages), Instructions d'installation (5 pages)

Imprimer la page
Whirlpool 36'' Freestanding Gas Range Manuel d'instructions d'installation
orifice spuds
notches
NAT
L.P.
gas
manifold
L.R.
L.F.
5.
Locate Natural gas orifice spuds in
literature package included with the range. All
Natural gas orifice spuds are stamped with "54".
Remove L.P. gas orifice spuds using a 3/8"
combination wrench. Install Natural gas orifice
spuds to replace the L.P. gas orifice spuds.
Place L.P. gas orifice spuds in plastic parts bag
for future use and keep with literature package.
Reinstall burners. Lower maintop to operating
position. Reinstall burner grates.
air shutter
hood
pin
L.P. gas
decrease gas
decrease
Natural gas
flame size
increase gas
increase flame
size pre-set at
factory for Natural
gas
6.
Oven burner: Use 1/2" combination
wrench to loosen the orifice hood away from the
pin (approximately 2 to 2-1/2 turns). The burner
flame cannot be properly adjusted if this
conversion is not made.
gas
manifold
OFF
T
P
A
L
N
selector
7.
key
Check that the oven control knob is in the
"OFF" position. Remove all control knobs.
Remove manifold cover by removing screws
above oven door. Locate selector key on oven
thermostat and turn clockwise to the Natural
position. Replace manifold cover and control
knobs. Allow enough time for Natural gas to fill
the pilot gas line. Light the pilot light.
8.
Complete section E, Page 6. Check for
proper flame. Natural gas flames do not have
yellow tips.
Page 8
Remove and
replace orifice
spuds.
R.F.
R.R.
shutter screw
thermostat