Fire Hazard
Do Not use an open flame to test
for leaks from gas connections.
Checking
for leaks with a flame
may result In a flre or exploslon.
16
Use a brush and liquid
n deteraent
to test all aas
connecrrons for le;ks. Bubbles around
connections will indicate a leak. If a
leak appears, shut off gas valve controls
and adjust connections. Then check
connections again.
NEVER TEST FOR GAS
LEAKS WITH A MATCH OR OTHER FLAME.
Clean all detergent solution from range.
Electronic
Ignition
System
Cookfop and oven burner use
electronic
ignitors in place of standing
pilots. When the cook-fop control knob is
turned to the "LITE" position, the system
creates a spark to light the burner. This
sparking continues until the control knob
is turned to the desired setting. When
the oven control is turned on, the ignitor
will spark until oven burner pilot is lit.
17 H
Check the
operatioi
of the
Cooktop
burners.
Push In
and turn each
control knob to
"LITE"
posItIon. The flame should light
within
4 seconds.
Do not leave the knob In the 'LITE"
posltlon after burner Ilghts.
18
After burner lights, turn
n control knob to "HI" bosition.
CheCK
each cooktop burner foiproper
flame. The small inner cone should have
a very distin.ct blue flame l/h" to YY long.
The outer cone is not as distinct as the
~
inner cone.
)
ii burners need adjusting for
1 brober flame. adiust the air
sneer to-&
wi'aest opening
that will not
cause the flame to lift or blow off the
burner Repeat as necessary with each
burner:
20
n
Push in and turn the control knob to the
"LITE" position and then to a low position.
The low flame should be a minimum,
steady, blue flame.
21
n
22
Check the oven burner for
4 proper flame. This flame
should be
Y2"
long, with inner cone of
bluish-green, an outer mantle of dark
blue and should be clean and soft in
character No yellow tips, blowina or
lifting of flameshoul
'
If oven flame needs to be
n adiusted, turn oven off.
Loosen screw and adjust air shutter. Turn
oven back on and check flame.
Repeat as needed until proper flame
appears. Tighten screw. Replace oven
bottom and oven rack.
You have Just
flnished Installing your
new Whirlpool range. To get the
most efficient use from your new
range, read your Whirlpool Use & Care
1
Congratulations!
\
Gulde. Keep Instaliatlon Instructions
and Guide close to range for easy
reference. The lnstructlons will
Check tne oven burner for proper
flame. Open the oven door and broiler
drawer, Remove the lower oven rack
and oven bottom. Push in and turn oven
control knob to 300°F. The oven burner
should light in 50-60 seconds. This delay
is normal. The oven safety valve requires
a certain time before it will open and
allow aas to flow
PANEL D
Imprimer la page