Whirlpool 968 Manuel d'utilisation - Page 9

Parcourez en ligne ou téléchargez le pdf Manuel d'utilisation pour {nom_de_la_catégorie} Whirlpool 968. Whirlpool 968 10 pages. Decorative deep silent stainless steel cooker hood, akr 968 ix

Imprimer la page

Control panel special functions

Setting the clock

The clock can be set at any moment except when the timer

function is in use.

The clock can be displayed in the standard 12 hour clock

version with a display from 1:00 to 12:59.

To set the clock, press the "Timer" button for 5 seconds,

then use the "+" and "-" buttons to set the time.

The time can be adjusted with 1 minute increases/decreases,

but if the "+"/ "-" buttons are pressed for 1 second, the time

is increased/decreased in 5 minute steps. During this option,

the appliance rounds off to the nearest 5 minutes.

To complete the time-setting procedure, press the "Timer"

button.

If after 1 minute no button is pressed, the set value is

accepted, the appliance adds 1 minute to this and starts

counting.

Grease Filter Indicator

After 40 hours of motor operation, the display shows

"Grease Filter". When this indication appears on the display,

the filter needs to be washed.

To reset the grease filter indicator, the user must press the

"+" button for 5 seconds: after this, the "Grease Filter"

warning disappears, resetting is confirmed by a "beep", and

the display shows the normal operation functions.

After this procedure, the grease filter counter returns to

zero.

Carbon Filter Indicator

After 160 hours of motor operation, the display shows

"Charcoal Filter". When this indication appears on the

display, the filter needs to be replaced.

To reset the carbon filter indicator, the user must press the "-

" button for 5 seconds:

after this, the "Charcoal Filter" warning disappears, resetting

is confirmed by a "beep", and the display shows the normal

operation functions.

After this procedure, the carbon filter counter returns to

zero.

5019 318 33305

H RUS BG RO

"Enabling/Disabling" the Carbon Filter Indicator

The carbon filter indicator can be enabled or disabled by

pressing the "-" and "+" buttons at the same time for 5

seconds. The motor and light must be switched off in order

to disable or enable the carbon filter.

Carbon Filter excluded: the filter alarm is disabled.

Enabling/ Disabling the Acoustic Signal

The acoustic signals can be activated or disactivated by

pressing the "Light" button for 5 seconds.

When the acoustic signal is activated, a tone is emitted and

the symbol "Snd" appears on the display for 2 seconds.

When the acoustic signal is disactivated, the symbol "Snd"

appears on the display for 2 seconds but no sound is emitted.

Temperature alarm

The hood is equipped with a temperature sensor that

activates the motor at speed 2 if the ambient temperature

around the display area exceeds 70° C (the system monitors

the temperature read by the sensor every 250 ms).

If the motor is switched OFF or is operating at speed 1 and

the temperature alarm is tripped, the motor switches to

speed 2 and the display shows "care". During this alarm

condition the user can only increase the motor speed (3rd

and 4th speed). When the hood temperature returns below

the alarm threshold, the motor reverts to the pre-alarm

operating condition. 3 minutes after the alarm is tripped, the

system again verifies the ambient temperature around the

display area: if below 70° C, the pre-alarm operating

conditions are restored.