Whirlpool AKR 953 Fiche d'installation - Page 20

Parcourez en ligne ou téléchargez le pdf Fiche d'installation pour {nom_de_la_catégorie} Whirlpool AKR 953. Whirlpool AKR 953 20 pages.
Également pour Whirlpool AKR 953 : Fiche d'installation (10 pages)

Imprimer la page

31833159.fm Page 20 Friday, April 1, 2005 6:35 PM

AKR 951 - AKR 953 - AKR 960 - AKR 810

1. Control panel.

2. Grease filter.

3. Halogen bulbs.

4. Steam deflector.

5. Telescopic flue.

To clean the grease filter

Wash the grease filter at least once a month.

1. Disconnect the electrical power supply

2. Remove the grease filters - Fig. 2: pull the spring

release handle (f) downwards, then remove the

filter.

3. After cleaning the grease filter refit in reverse

order, making sure the entire extraction surface is

covered.

Carbon filter Fitting and Maintenance

Fitting the carbon filter:

1. Disconnect the electrical power supply.

2. Remove the grease filter (f - Fig. 2).

3. Turn the side knobs 90° and then remove the

filter holder (g - Fig. 3).

4. Fit the carbon filter (h - Fig. 3) in the filter holder

(i - Fig. 3).

5. Refit the filter holder and secure it to the hood

with the screw (g - Fig. 3).

6. Refit the grease filter.

Carbon filter maintenance:

Unlike traditional carbon filters, this carbon filter can

be washed and reactivated.

With normal hood use, the filter should be cleaned

once a month. The best way to clean the filter is in a

dishwasher at the highest temperature possible, using

a normal dishwasher detergent. To avoid particles of

food or dirt settling on the filter during washing and

giving rise to unpleasant smells, it is advisable to wash

the filter on its own. After washing, dry the filter in the

oven at 100° C for 10 minutes to reactivate it.

The filter will retain its odour-absorbing capacity for

three years, after which it must be replaced.

Replacing bulbs

1. Disconnect the electrical power supply.

2. Use a small screwdriver or any other suitable tool

to prise off (m-Fig. 4) the lamp cover (p-Fig. 4).

3. Remove the burnt-out bulb.

Replace using 20 W max halogen bulbs only,

making sure not to touch them with your hands.

4. Close the lighting unit (snap-close).

5019 318 33159

PRODUCT SHEET

CONTROL PANEL

B+C.Speed 2 selector switch

B+D.Speed 3 selector switch

H RUS BG

Light ON/OFF switch.

ON/OFF and speed 1 selector switch

(small amount of steam and fumes).

(medium amount of steam and fumes).

(large amount of steam and fumes).

Fig. 1

Fig. 2

Fig. 3

Fig. 4