Whirlpool Eyelevel Convertible Range Hood Manuel d'instructions d'installation - Page 4

Parcourez en ligne ou téléchargez le pdf Manuel d'instructions d'installation pour {nom_de_la_catégorie} Whirlpool Eyelevel Convertible Range Hood. Whirlpool Eyelevel Convertible Range Hood 7 pages.

Imprimer la page
Now start...
With range hood in kitchen.
1
1
n
Open front of hood and remove
filter. Loosen four wing nuts that
attach fan to hood. Remove fan
power pack.
2
n
Determine which venting
method (roof, wall or nonvented)
you
need to use. This range hood is
shipped for vented installation. If
nonvented
installation is desired, follow
instructions on Panel D.
Vented installation
#
3
Remove knockout from the
n
vent opening to be used.
Personal Injury Hazard
More than one person is required to
he,,
4th appliance
installation
because of its weight and size.
Failure to follow these instructions may
result in personal injury.
4
II
II I
n
Check that range is centered
in
cabinet opening. Lift and place the
range hood on top of range. Reach
through the hood and mark the outline
of the vent opening on the cabinet
bottom or back wall. You can also use
the product dimensions given on Panel
A to mark the vent location.
Property Damage
*Slide cardboard
or hardboard
under range before moving range
across floor.
Failure to follow this instruction may
result in damage to floor covering.
5
n
Remove hood and set aside on
a protected
surface. Disconnect and
move range from cabinet opening to
provide easier access to upper
cabinet or rear wall.
6
n
Check that the vent opening was
correctly marked. The vent opening
should be centered between the
cabinets and large enough to fit 3-l/4" x
10" ductwork. Use a saber saw to cut
rectangle
opening for ductwork.
3-1
7
1
n
Install ductwork through the vent
opening in upper cabinet or wall.
Complete venting system according
to
method needed. See Venting
requirements. Use caulking to seal
exterior wall or roof opening.
8
n
Attach damper to hood. If
damper is attached
to the back of
hood, be sure damper hinge is toward
the top. Replace fan power pack.
Replace filter.
9
n
Place range hood on top of range
and lift front of hood. Connect
power
supply cord to receptacle
in top of
range.
h
3. 8.
Numbers
correspond
to steps.
*Disconnect
electrical
power at the
service panel (fuse box or circuit
1 breaker box).
i Failure to do
SO
could result in
electrical shock or other personal
injury.
Panel C