Whirlpool GZ5736XRS Instructions d'installation et manuel d'utilisation et d'entretien - Page 9

Parcourez en ligne ou téléchargez le pdf Instructions d'installation et manuel d'utilisation et d'entretien pour {nom_de_la_catégorie} Whirlpool GZ5736XRS. Whirlpool GZ5736XRS 24 pages. Gz5730xr series, gz5736xr series 30" (76.2 cm) and 36" (91.4 cm) convertible range hood

Imprimer la page
WARNING
Electrical Shock Hazard
Disconnect power before servicing.
Replace all parts and panels before operating.
Failure to do so can result in death or electrical shock.
1. Disconnect power.
2. If not previously done, run wiring through wall or cabinets
according to electrical codes and ordinances.
3. Stand hood up. Feed the power supply cable through the
strain relief.
A. UL listed or CSA approved strain relief
4. Use twist-on connectors and connect black wires together.
A
A. White wires
B. Factory assembled ground connection
C. Black wires
D. Green ground screw
E. Ground wire
F. UL listed or CSA approved strain relief
5. Use twist-on connectors and connect white wires together.
6. Connect the power supply ground wire to the green ground
connector and tighten securely.
7. Securely tighten the strain relief.
8. Replace the wiring cover.

Make Electrical Connection

Direct Wire Installation
A
B
C
D
E
F
WARNING
Fire Hazard
Electrically ground the blower.
Use copper wire.
Connect ground wire to green ground screw in
terminal box.
Failure to do so can result in death, fire, or
electrical shock.
UL-Listed Power Supply Cord Kit (U.S. Only)
1. Connect a UL-listed power cord kit (Part Number HOODPT3)
following the kit instructions for connecting the wires.
2. Replace the wiring cover.

Install Range Hood

WARNING
Excessive Weight Hazard
Use two or more people to move and install
range hood.
Failure to do so can result in back or other injury.
1. Remove the 4 range hood mounting screws from the bag
containing parts and install in previously drilled
pilot holes. Leave screw heads about
shim strips.
"
(6.4 mm)
2. Lift range hood into final position, feeding electrical wire
through wiring opening. To avoid damage, do not push on fan
blade.
3. Position the range hood so the that large end of the keyhole
slots are over the screws. Then push the hood toward the
wall so that the screws are in the neck of the slots.
" (3.0 mm)
" (6.4 mm) away from
9