Whirlpool GZ9736XSS Instructions d'installation et manuel d'utilisation et d'entretien - Page 12
Parcourez en ligne ou téléchargez le pdf Instructions d'installation et manuel d'utilisation et d'entretien pour {nom_de_la_catégorie} Whirlpool GZ9736XSS. Whirlpool GZ9736XSS 32 pages. 30" (76.2 cm) and 36” (91.4 cm) wall-mount canopy range hood
Également pour Whirlpool GZ9736XSS : Manuel des dimensions (1 pages)
Imprimer la page
11. Install charcoal filter by inserting tabs of filter into housing as
shown. Press inward on the clamp and rotate the filter
upward until the clamp engages the housing.
A. Tabs
B. Clamp
12. Install metal grease filters by inserting the back edge of filter
into the rear channel of the filter opening. Push handle toward
the rear and push the filter up. Push filter toward the front and
insert into the front channel.
A. Metal grease filters
13. Reconnect power.
Complete Installation
0 1
A
A. Light switch
B. Blower switch
1. Move the light switch to "1" position. The light should turn on.
2. Move blower switch to "1" position. The blower should
operate.
3. Move the blower speed switch to "1" position for low speed,
"2" position for medium speed or "3" position for high speed.
4. Move blower and light switches to "0" position to turn off
blower and light.
5. If range hood does not operate, check to see whether a
circuit breaker has tripped or a household fuse has blown.
NOTE: To get the most efficient use from your new range hood,
read the "Range Hood Use" section.
12
A
B
A
0 1 2 3
B
RANGE HOOD USE
The range hood is designed to remove smoke, cooking vapors
and odors from the cooktop area. For best results, start the hood
before cooking and allow it to operate several minutes after the
cooking is complete to clear all smoke and odors from the
kitchen.
The range hood controls are located on the underside of the
canopy.
0 1
A
A. Light switch
B. Blower switch
Range Hood Controls
Operating the light
1. Move the light switch to the "1" position to turn on the light.
2. Move the light switch to the "0" position to turn off the light.
Operating the blower and adjusting blower speed
1. Move the blower switch to the "1" position for low speed, the
"2" position for medium speed or the "3" position for high
speed.
2. Move the blower switch to the "0" position to turn off the
blower.
Heat Sensing
This range hood is equipped with a heat sensing thermostat. This
thermostat is a device that will turn the blower on or speed the
blower up if it senses excessive heat above the cooking surface.
If the blower is off, the heat sensing thermostat will turn the
blower on to high speed.
If the blower is on at a lower speed setting, the heat sensing
thermostat will turn the blower up to high speed.
When the temperature level drops to normal, the blower will
return to its original setting.
RANGE HOOD CARE
Cleaning
IMPORTANT: Clean the hood and grease filters frequently
according to the following instructions. Replace grease filters
before operating hood.
Be sure lights are cool before cleaning the hood.
Exterior surfaces
Clean the range hood with a mild detergent and soft cloth. Do not
use abrasive cleanser or steel-wool pads.
Metal grease filters
The filters should be washed frequently. Place metal filters in
dishwasher or hot detergent solution to clean. Drain water
through edge holes and let each filter dry thoroughly before
replacing it.
0 1 2 3
B