Whirlpool KPEC992MSS Manuel d'utilisation et d'entretien - Page 5
Parcourez en ligne ou téléchargez le pdf Manuel d'utilisation et d'entretien pour {nom_de_la_catégorie} Whirlpool KPEC992MSS. Whirlpool KPEC992MSS 10 pages. 36/48" (91.4/121.9 cm) hood liner installation instructions
Imprimer la page
Whirlpool
- CIC
8/16/04
2:25
PM
PAGE
1/21
RightFax
green
green
black
white
ground
ground
wir_
win=
white
ecrew
wires
(from
(from
wire_
blowed
blower}
"brown wire
(from hood
liner)
\ blue wire
(from hood
liner)
power
blower
hood liner
supply
wiring
wiring
cablo
Connect both green ground wires
(from exterior blower motor and
from 120-volt supply wiring)
under the unused green ground
screw.
120-volt supply wiring:
* Connect 120-volt black supply
wire to black hood tiner wire with a
twist-on connector.
• Connect 120-volt supply white
wire with to white hood liner
wire with a twist-on connector.
Exterior blower motor
wiring:
• Connect the black blower motor
wire to the blue hood liner wire
with a twist-on connector.
• Connect white
blower motor
wire to brown hood liner wire
with a twist-on
connector.
3.
Tighten strain reliefscrews.
4.
Replace widng box cover.
Tighten screw securely.
5=
Connect exterior blower
vent system to hood liner collar.
Seal joint with duct tape to make
airtight.
6=
Reconnect power.
_d
light
blower motor
switch
_witch
7=
Check operation of hood
liner and exterior blower.
Lights:
• Move the light switch to "1"
position. Lights should go on.
Move switch back to "0"
position. Lights should go off.
Exterior blower motor and speed
control:
• Move motor switch to "1"
position. Exterior blower motor
should turn on.
• Move speed control switch to
vary the blower speed from low
(at the left) to high (at the right).
• Move speed control switch back
to low (at the left). Move the
motor switch backto "0"and the
blower motor should turn off.
8,
Reinstallfilters. Place back
edge of filter'into channel at rear of
hood liner.Push filter up while
pushingtab back. When filter is in
place, release tab, Lockingpin will
hold filter in place. Repeat with
other filter(s).
9.
Installfront enclosure.
To get the most efficient use from
your new hood liner, read the
"Use and Care Information"
section. Keep your KitchenAid
Installation Instructions and Use
and Care Guide close to hood
liner for easy reference.