Whirlpool UXD8630DYS0 Manuel d'utilisation et d'entretien - Page 11

Parcourez en ligne ou téléchargez le pdf Manuel d'utilisation et d'entretien pour {nom_de_la_catégorie} Whirlpool UXD8630DYS0. Whirlpool UXD8630DYS0 36 pages. 30" and 36" retractable (pop-up) downdraft vent system

Imprimer la page

Left or Right Venting:

1. Using two or more people, place the downdraft vent system

on its back.

2. Remove the 4 screws from the cover plate mounted to the

face of the motor box and set them aside.

A. Cover plate

D. Motor mounting screws (4)

B. Cover plate screws (4)

E. Vent cover plate

C. Cover plate keyhole slot shoulder

F. Motor box

screws (4)

G. Vent cover screws (3)

3. Slide the cover plate up and slip it over the keyhole slot

shoulder screws. Set the cover aside.

4. Remove 4 screws from the bottom of the motor box that hold

the motor assembly to the motor box.

NOTE: Disconnect

the electrical wiring connection from

motor if needed.

5. Remove 3 screws and the vent cover plate from the left or

right side of the motor box for the venting direction to be

used.

6. Rotate the blower motor assembly 90 degrees to the left or

right side to the chosen venting direction and secure to the

blower box with motor mounting screws previously removed.

Do not twist or bind the wires.

7. Install the vent cover plate over the rectangular opening in the

bottom of the motor box and secure with vent cover screws.

NOTE: Reinstall the electrical wiring connection to motor if

removed.

8. Reinstall the cover plate to the face of the motor box and

secure with 4 cover plate screws previously removed.

9. For mounting the blower motor to the back of the vent box,

go to the "Rear Mounting--Blower

Motor" section.

Otherwise, go to the "Complete

Installation" section.

Mo$o

NOTE: Optional blower motor rear mounting position (opposite

side) for island cabinet locations. The blower motor box

assembly can be moved to the opposite side (rear) of the vent

box.

1. Remove 7 screws from the mounting flanges of the blower

motor box.

Front View

A. Screws (7)

B. Keyhole slot shoulder screws (2)

C. Blower motor box

2. Lift blower motor box off the shoulder screws in the keyhole

slots. Disconnect

wire connection

from blower motor and set

blower motor box aside.

3. Remove 6 screws from the mounting flange of the

1_,,(6.4 mm) deep cover.

Rear View

A. Screws (6)

B. Keyhole slot shoulder screws (2)

C. ¼" (6.4 mm) deep cover