Whirlpool UXT30 Instructions d'installation - Page 2
Parcourez en ligne ou téléchargez le pdf Instructions d'installation pour {nom_de_la_catégorie} Whirlpool UXT30. Whirlpool UXT30 4 pages.
Imprimer la pageWARNING
Electrical Shock Hazard
Disconnect power before installing light switch.
Electrically ground range hood and light switch by
connecting ground wire to the ground screw in the
switch box.
Replace all parts and panels before operating.
Failure to do so can result in death or electrical shock.
B A
I
A. White wires (N)
B. Black wires (L)
C. UL Listed wire connector
D. Green (or bare) ground wire
E. Home power supply cable
#14 UL Approved cable
1. Mount the switch box on the wall in an easily accessible area
15" (38 cm) to 40" (1 m) above the floor. Avoid reaching over
the cooking surface.
For a single pole toggle light switch: Install a 3
deep single-gang switch box.
INSTALLATION INSTRUCTIONS
C D
F
G
H
E
F. Range hood cable
G. UL Listed or CSA Approved
1/2" (13 mm) strain relief
H. Green ground screw
I. UL Listed single pole toggle
light switch
/
" (8.9 cm)
1
2
2. Attach the power cable to the switch box.
Clamp wiring to switch box and unit using a UL Listed
or CSA Approved 1/2" (13 mm) strain relief. Provide
6" (15.2 cm) leads inside box and fan for easier wiring.
3. Connect wiring.
General instructions for all models:
Make sure both the single pole toggle light switch and
■
the range hood are properly grounded.
Make sure the ground wire is securely fastened to the
■
single pole toggle light switch ground screw. Tighten
ground screw.
Use proper wire nut sizes for number and size of wires.
■
Tighten screw terminals.
■
Make electrical connections, following appropriate
■
diagram.
120 VAC
BLACK
L
WHITE
N
GRND
4. Mount single pole toggle light switch in switch box.
Tuck wires into switch box and fasten the control to box
using attached screws.
5. Attach switch plate.
Fasten the switch plate to the control using the short screws
from the parts bag.
6. Set the fan speed and light on the range hood to your
preference. The light switch will turn the range hood on and
off using your settings.
RANGE HOOD
SINGLE
POLE
LIGHT
LOAD
SWITCH