Whirlpool UXT4036AD Instructions d'installation et manuel d'utilisation et d'entretien - Page 7

Parcourez en ligne ou téléchargez le pdf Instructions d'installation et manuel d'utilisation et d'entretien pour {nom_de_la_catégorie} Whirlpool UXT4036AD. Whirlpool UXT4036AD 24 pages. 30" and 36" (76.2 and 91.4 cm) range hood
Également pour Whirlpool UXT4036AD : Instructions d'installation et manuel d'utilisation et d'entretien (28 pages), Instructions d'installation et manuel d'utilisation et d'entretien (24 pages), Instructions d'installation et manuel d'utilisation et d'entretien (24 pages), Instructions d'installation et manuel d'utilisation et d'entretien (24 pages)

5. Mark Hole Locations

Lift the range hood into place and insert the mounting bracket

tabs through the slots in the back of the range hood.

Hold the range hood firmly in place with one hand and

bend each mounting tab (A) upward approximately 90°.

Mark the hole at the power supply knockout (B).

OPTIONAL: Mark the hole in each mounting tab.

Remove the range hood and set it aside.

90˚

6. Drill Electrical Opening

Using a 1

" (3 cm) drill bit, drill the hole in the dot

marked previously at the electrical strain relief.

OPTIONAL: Using a

" (3 mm) drill bit, drill pilot holes

for the dots marked previously at each mounting tab

at an approximate 45° angle in an upward direction.

7. Prepare Range Hood Vents

and Mounting Tabs

Install Strain Relief

■

Install a UL Listed/CSA Approved

strain relief (A).

Mounting Tabs

■

Start a #8-18 x

" (4.2 x 16 mm) truss-head screw into

the mounting tab (D) on each side of the range hood

as shown in the inset. Insert the screws approximately

2 turns into the mounting tab holes.

Non-vent (Recirculating) Installations

■

Remove the (2) T10 Torx

front rectangular vent cover (B).

†

TORX is a registered trademark of Acument Intellectual Properties, LLC.

" (13 mm)

screws and remove the top,

®†