Whirlpool W10907091A Instructions d'installation et manuel d'utilisation et d'entretien - Page 8

Parcourez en ligne ou téléchargez le pdf Instructions d'installation et manuel d'utilisation et d'entretien pour {nom_de_la_catégorie} Whirlpool W10907091A. Whirlpool W10907091A 24 pages. 30" and 36" (76.2 and 91.4 cm) range hood

Imprimer la page

8. Mount Range Hood

Lift the range hood into place, positioning the rear slots

■

over the mounting brackets.

Using a Phillips screwdriver, push on the screws that

■

are started into the top mounting tabs and bend the

tabs against the cabinet side walls. Attach the screws

to the cabinet side walls.

IMPORTANT: Do not overtighten the screws.

For direct wire installations, run the home power supply

■

cable according to the National Electric Code or CSA

standards and local codes and ordinances. There must

be enough wiring from the fused disconnect (or circuit

breaker) box to make the connection in the range hood

electrical terminal box.

Tighten the strain relief screws.

■

NOTE: Do not reconnect power until the installation

is complete.

OPTIONAL: If you prefer, bend the rear tabs against

the rear of the range hood and attach to the wall using

#8-18 x

" (4.2 x 16 mm) truss-head screws.

9. Make Electrical Connection

Option 1 - Direct Wire Installations

Use a UL Listed/CSA Approved wire connector

■

and connect the 3 white wires (A) together.

Use a UL Listed/CSA Approved wire connector

■

and connect the 2 black wires (B) together.

WARNING

Fire Hazard

Electrically ground the blower.

Use copper wire.

Connect ground wire to green ground screw in

terminal box.

Failure to do so can result in death, fire, or

electrical shock.

Connect the green (or bare) ground wire (C) from the

■

power supply to the green ground screw in the electrical

box and tighten the screw securely.

Reinstall the electrical box cover.

Reconnect power.

Option 2 - Power Cord Kit Installations

For optional power cord kit installations, follow the instructions

supplied with the power cord kit. See the "Assistance or

Service" section for information on ordering.

NOTE: Use only with range hood cord connection kits that

have been investigated and found acceptable for use with

this model range hood.

10. Complete the Installation

Install a 120V, 75W maximum, light bulb with

■

E26 base. See "Replacing the Light Bulb" in

the "Range Hood Care" section.

If removed previously, replace the filter. See "Charcoal

■

Grease Filter" in the "Range Hood Care" section.

Check the operation of the range hood fan and light.

■

See the "Range Hood Use" section.

If the range hood does not operate, check to see whether

a circuit breaker has tripped or a household fuse has blown.

Disconnect the power and check the wiring connections.

NOTE: To get the most efficient use from your new

range hood, read the "Range Hood Use" section.