Backyard Plus Lift ’n Glide Instructions

Parcourez en ligne ou téléchargez le pdf Instructions pour {nom_de_la_catégorie} Backyard Plus Lift ’n Glide. Backyard Plus Lift ’n Glide 3 pages. Retractable cover system

Imprimer la page

READ INSTRUCTIONS COMPLETELY BEFORE BEGINNING INSTALLATION

Kit components

1. Right side assembly

2. Left side assembly

3. Hardware bag & template

Hardware Bag contents

• 20 x Phillips 1 ½" pan head screws

Tools Needed

1. Tape

2. 7/16 wrench (2)

3. #2 Phillips screwdriver

4. Drill motor with 1/8" drill bit

ASSEMBLY INSTRUCTIONS

Locate Mounting points on spa cover

1. Left and Right orientation is determined by standing at the back of the spa. Covers on the

Grandee (G) and Landmark (S) open from side to side, so Left and Right orientation is

determined by standing at the back of the spa cover. Note the position of the cover warning

label and the equipment compartment. Position the cover on the spa, ensuring that the rear

half of the cover (opposite the warning label) is positioned on the rear half of the spa. (See

above)

2. Unfold and place the template on the left side of

the cover as shown with the side marked "Left

side" facing upward.

3. Fold the tabs of the template where marked and

tape down to the rear and side of the spa cover

as shown.

4. Drill the hole (B) marked on the template with

the 1/8" drill into the side of the cover. The hole

will go through an aluminum plate.

5. Remove the template and repeat the procedure

on the right side of the cover. Make sure the template is turned over and the side marked

"Right side" is facing up. Remove the template when finished.

Lift 'n Glide

Retractable Cover System

Page 1

5/14/2007 - Rev B.

US Patent #7,010,833