Firesense LIP-10A-TGG-NTS-1 Manuel - Page 12

Parcourez en ligne ou téléchargez le pdf Manuel pour {nom_de_la_catégorie} Firesense LIP-10A-TGG-NTS-1. Firesense LIP-10A-TGG-NTS-1 17 pages. Outdoor patio heater

Imprimer la page

OPERATING INSTRUCTIONS

3. If leak is detected at regulator/gas source valve connection, disconnect, reconnect, and perform another leak

test. If you continue to see bubbles after several attempts, cylinder valve is defective. Call our customer service

hotline at 1-866-985-7877, 9 a.m. – 6 p.m., EST, Monday – Friday

IF NO BUBBLES APPEAR AT ANY CONNECTION, THE CONNECTIONS ARE SECURE.

Note: Whenever gas connections are loosened or removed, you must perform a complete leak test.

Caution: Do not attempt to operate this appliance until you have read and understand all Safety Information in

this manual and all assembly is complete and leak tests have been performed.

Before Turning Gas Supply ON:

1. Your heater was designed and approved for OUTDOOR use only. Do NOT use it inside a building, garage, or

any other enclosed area.

2. Make sure surrounding areas are free of combustible materials, gasoline, and other flammable vapors or

liquids.

3. Ensure that there is no obstruction to air ventilation. Be sure all gas connections are tight and there are no

leaks.

4. Be sure the natural gas cover is clear of debris. Be sure any component removed during assembly or servicing

is replaced and fastened prior to starting.

Before Lighting:

1. Heater should be thoroughly inspected before each use, and by a qualified service person at least annually. If

re-lighting a hot heater, always wait at least 5 minutes.

2. Inspect the hose assembly for evidence of excessive abrasion, cuts, or wear. Suspected areas should be leak

tested. If the hose leaks, it must be replaced prior to operation. Only use the replacement hose assembly

specified by the manufacturer.

Lighting:

NOTE: For initial start or after any natural gas source, hold the control knob in for 2 minutes to purge air from

all gas lines before proceeding.

1. Turn the control knob to the "OFF" position.

2. Fully open the gas source valve.

3. Turn the control knob half way between the small flame and the large

flame symbols.

4. Push control knob in and then push the RED igniter button to ignite the

main burner. Repeat until the burner ignites. Keep the control knob fully

pushed in for an additional 30 seconds after the burner ignites, then

release the control knob.

5. To increase the flame, turn the control knob clockwise toward the large

flame symbol. To decrease the flame, turn the control knob counter

clockwise towards the small flame symbol.

6. To turn the appliance OFF, push down the control knob and turn

clockwise to the OFF position.

7. Wait at least 5 minutes before attempting to re-light the heater.

8. Turn the natural gas source valve to OFF or closed.

If you experience any ignition problems, please consult "Troubleshooting" on page 15.

Caution: Avoid inhaling fumes emitted from the heater's first use. Smoke and odor from the burning of oils used in the manufacturing will

appear. Both smoke and odor will dissipate after approximately 30 minutes. The heater should NOT produce thick black smoke.