Firetide HotPort 6101 Manuel d'installation rapide - Page 2

Parcourez en ligne ou téléchargez le pdf Manuel d'installation rapide pour {nom_de_la_catégorie} Firetide HotPort 6101. Firetide HotPort 6101 2 pages. 6100 series
Également pour Firetide HotPort 6101 : Manuel d'installation du matériel (20 pages)

Imprimer la page

Installing the Node

Indoor node installation is straightforward. Place the unit on a

table or shelf, or use the optional bracket to attach it to a wall,

ceiling, or cubicle partition. Apply power. The power LED should

illuminate immediately; after about 60 to 90 seconds, the status

LED should switch to steady green.

Note the location of the reset button in the lower right corner of

the rear panel. A paperclip can be used to reset the unit after it

has fully booted and the status light has come on.

Antenna Placement

The dual-radio capability of the Series 6102 nodes must be consid-

ered when selecting operating frequencies and arranging anten-

nas. Each transmitter is powerful enough to drown out the other

unless steps are taken to provide adequate isolation.

The easiest solution is to operate one radio in the 2.4 GHz band

and the other radio in the 5 GHz band. This provides sufficient

isolation to avoid overload problems.

If this is not possible, you must select and place the antennas to

achieve the necessary isolation. You can do this with any of sev-

eral techniques.

Omnidirectional antennas transmit in a plane perpendicular

to the shaft of the antenna. If one antenna is higher or low-

er than the other one, sufficient isolation can be provided.

In some cases, simply pointing one antenna "up" and one

"down" may be sufficient.

If the two omnidirectional antennas must be placed in the

same plane, mount them at least 1.6 meters (5ft.) apart.

HotPort Series 6100 Quick Install Guide Revision 1.03 041907 700-0078-005

The contents of this Installation Guide are subject to change without notice.

Please refer to the Firetide web site, www.firetide.com, for current versions.

HotPort Series 6100 Mesh Node - Front View

HotPort Series 6100 Mesh Node - Rear View

AC Power Brick

Optional Mounting Bracket

Auxiliary Bracket

HotPort Mesh Node

Main Mounting Bracket