Firewarm stoves FIREWARM 6 Instructions d'installation et de fonctionnement - Page 11

Parcourez en ligne ou téléchargez le pdf Instructions d'installation et de fonctionnement pour {nom_de_la_catégorie} Firewarm stoves FIREWARM 6. Firewarm stoves FIREWARM 6 16 pages. Freestanding multifuel stoves
Également pour Firewarm stoves FIREWARM 6 : Manuel d'installation et d'utilisation (14 pages)

Imprimer la page

Warning! This appliance will be hot when

In operation and due care should be taken

When operating the controls.

Air Controls

Primary Air

Primary air is controlled via the two rotary air controls on the bottom of the door.

This provides a conventional air draught to the bed of the fire. The primary air intakes

can be adjusted to give the best possible results when burning different fuels.

Secondary Air

The cast iron stove is fitted with a sophisticated "air wash" system. This secondary air

supply to the stove is controlled through a slider assembly located at the top of the stove.

Multifuel Grate

Your Firewarm Stove is fitted with a rotary style grate, which is operated from the front

of the stove via a riddle rod. Use the "Hook" end of tool to operate the riddling system.

This rotary grate is located in the centre of a cast iron flat bed with suitable air slots that

assist the burning of most fuels. It is important to use the rotary grate to de-ash regularly,

to ensure that the primary airflow is not impeded, as a build-up of ash can damage the

cast iron bed.

Ashpan

It is essential that you empty the ashpan regularly. Use the "T" end of tool to lift the

ashpan out of the stove.

Notes on Wood burning

With a full load of wood, the stove will need to be refuelled approximately every 1.5

hours. Wood can be stacked higher in the stove than solid mineral fuel but care must be

taken that logs do not touch the baffle.

Wood burns most efficiently with the primary air controls closed and the secondary

control partially open. Moving the secondary control will control the burn rate of the

stove.

Note – primary and secondary air is needed to light the stove, see section entitled

„Lighting the Stove‟.

Wood burns best on a bed of ash and it is therefore only necessary to remove surplus ash

from the stove occasionally.

Burn only dry, well-seasoned wood, which should have been cut, split and stacked for at

least 12 months, with free air movement around the sides of the stack to enable it to dry

out. Burning wet or unseasoned wood will create tar deposits in the stove and chimney

and will not produce a satisfactory heat output. Do not use liquid fuels in this appliance.