Ergo In Demand KTG-230 Manuel d'instructions d'installation - Page 4

Parcourez en ligne ou téléchargez le pdf Manuel d'instructions d'installation pour {nom_de_la_catégorie} Ergo In Demand KTG-230. Ergo In Demand KTG-230 8 pages. Horizontal and vertical table stands and accessories

Imprimer la page

Model: KTG-Series

(20)

(30)

Figure 1: Parts

ASSEMBLY AND INSTALLATION

Grommet Mount Installation

To install on a flat surface:

1. Locate desired point on surface where mount is to be

installed. (see Figure 2)

2. Drill a 1/2" dia. hole through surface.

3. Slide one 3/8-16 x 6" HHCS (100) upward through

lower grommet (110), through hole in surface and

through upper grommet (110).

4. Place pole (50, 60, 70) onto upper grommet (110)

aligning threaded hole in pole bottom with threaded

end of 3/8-16 x 6" HHCS (100).

5. Thread 3/8-16 x 6" HHCS (100) into pole bottom (50,

60, 70) and tighten to secure pole and grommets

(110) to surface.

6. Add pipe cap (40) to top of pole.

7. Mount Centris head assembly or array assembly to

rail following the instructions outlined in KTG-220,

320, And 440 Assembly section of this document.

(10 Includes 210, 220, 230)

250

240

(50)

(60)

(120)

(130)

260

(110)

(80)

(70)

(50, 60, 70)

(110)

(100)

Figure 2: Grommet installation

Mount Assembly

KTG-230 Assembly

8. Place front pole clamp with Centris Head (210)

against pole in approximate mounting location.

9. Place three BHCS (230) into rear pole clamp (220)

and place against pole aligning with front pole clamp

(210). (see Figure 3)

Installation Instructions

(160)

(180)

(200)

(190)

(140)

(100)

1/2" dia.

through hole

(170)

(40)