Firex PMDE100 Manuel d'instruction pour l'installation, l'entretien et l'utilisation - Page 12

Parcourez en ligne ou téléchargez le pdf Manuel d'instruction pour l'installation, l'entretien et l'utilisation pour {nom_de_la_catégorie} Firex PMDE100. Firex PMDE100 16 pages. Electric kettles

Imprimer la page
3.2.2. SWITCHING ON, START COOKING AND SWITCHING OFF
−
Fill the vat with hot or cold water, according to need, using the tap that the appliance is equipped with.
−
The appliance has a three-position selector to start cooking functions (see figure "Controls").
−
Here is a list of the procedures for a safe and correct use of the appliance.
Energising the unit:
−
Connect the appliance by turning on the main switch installed before it.
Cooking start:
Switch on the equipment (to be sure look at the display : display lighting the equipment in on)
-
-
Set the temperature according to cooking requirements :
press "SET" for 3 sec.
Two LEDs will light up (see chap. 4.3. part. nr.5), indicating the step of temperature setting.
With the arrows increase / decrease the temperature required.
To confirm the choice, press "SET" again, or wait 5 sec.
-
The heating starts (look the led lighting up, above left).
-
During the cooking time, to display the set temperature, press "SET" for a second. After 5 sec. it
comes back automatically to the actual temperature.
-
Just reaching the set temperature, the equipment keeps the cooking conditions required.
-
Switch off the equipment by the external master switch.
Cooking stop:
press "SET" for 6 sec.
-
-
appears "OFF", the heating set functions are deactivated
-
pressing it again for 6 seconds the previous functions are activated.
Please note : the thermostat keeps in the memory the last set point also cutting off the tension.
Both the thermostats, could be controlled with a HACCP connection (optional).
−
Do not use aggressive substances or abrasive detergents when cleaning the stainless steel
components.
−
Avoid using metal pads of the steel parts as they may cause rust. For the same reason, avoid contact
with materials containing iron.
−
Do not use sandpaper or abrasive paper for cleaning; in special cases use a powder pumice stone.
−
In case of particularly resistant dirt, it is advisable to use abrasive sponges (e.g. Scotch-Brite).
−
It is advisable to clean the appliance only once it has cooled down.
Instruction manual for installation, maintenance and use
Electric Kettles PMDE...

3.3. CLEANING AND CARE OF THE APPLIANCE

- GB -
12 di 16
Page