Clarisonic ARIA Manuel de l'utilisateur - Page 5

Parcourez en ligne ou téléchargez le pdf Manuel de l'utilisateur pour {nom_de_la_catégorie} Clarisonic ARIA. Clarisonic ARIA 7 pages. Sonic skin cleansing
Également pour Clarisonic ARIA : Manuel de l'utilisateur (20 pages)

Imprimer la page

CHARGING STAND

In order for the stand to act as a charging stand you will need to attach

the magnetic pLink charger.

1. Insert the USB end of the pLink charger

2. Insert the thick base of the pLink head

3. Press the plink into the hole until you

4. Plug the USB end of the pLink into your

5. Place the Aria into the stand. The

into the hole at the very center of the

stand base

Feed the cord through until the pLink

aligns with the "u" at the front of the

stand

into the small hole at the front of the "u"

hear a click and the pLink head is

supported without any gaps by the "u"

chosen power supply

illuminated bezel will begin to fade in

and out, indicating that the pLink has

magnetically attached to the handle

and charging is taking place.

CARING FOR YOUR Aria

To keep your Aria in optimum condition, care for it as follows. Do not use

abrasive cleansers or chemicals to clean any part of the Aria. Do not put

any part of the Aria in the dishwasher.

HANDLE

Once a week remove the brush head and wash the handle using warm

soapy water to remove any residue. The handle is sealed and fully

waterproof. Never attempt to open the brush handle for any reason.

pLink CHARGER

IMPORTANT: Unplug the pLink charger, then wipe it with a soft, damp

cloth. Do not immerse the charger in water.

DRYING STAND

Remove the pLink

charger from the drying stand. Wipe the drying stand

with a soft, damp cloth.

BRUSH HEADS

We recommend that the Clarisonic brush head

be replaced every 3 months as the bristles

become fatigued and less effective over time.

To remove the brush head, 1 Grip the brush

head firmly, then push and twist it counter-

clockwise (like a medicine cap). 2 Pull the

head away from the handle.

To attach the brush head, push down and twist

the head clockwise until it snaps into place. Be

sure you hear a tight snap.

TIP: Use the brush head cap to easily remove and

attach the brush head with a simple twist.

push down

pull away