Xerox 850DP - Phaser Color Solid Ink Printer Note de mise à jour - Page 20

Parcourez en ligne ou téléchargez le pdf Note de mise à jour pour {nom_de_la_catégorie} Xerox 850DP - Phaser Color Solid Ink Printer. Xerox 850DP - Phaser Color Solid Ink Printer 33 pages. Installation guide for accxes 10.2
Également pour Xerox 850DP - Phaser Color Solid Ink Printer : Spécifications (2 pages), Manuel de l'opérateur (16 pages), Manuel complémentaire (1 pages), Manuel complémentaire (11 pages), Manuel de configuration (1 pages), Manuel d'instructions de nettoyage (9 pages), Manuel de mise à jour (8 pages), Manuel complémentaire (26 pages), Note de mise à jour (11 pages), Note de mise à jour (11 pages), Instructions d'installation (2 pages)

Xerox 850DP - Phaser Color Solid Ink Printer Note de mise à jour

8.2 Xerox 6030/6050 Wide Format Solution

8.2.1 Long Plotting

Long plot limits are dependent on the amount of memory in the 6030/6050. Limits are as follows:
Amount of Memory
Installed
256 MB
512 MB
1 GB
If the maximum plot length in AccXES (in WebPMT: PRINTER DEFAULTS>PROCESSING
DEFAULTS>MEDIA>MAXIMUM PLOT LENGTH) is set greater than the maximum length of the
6030/6050 the image will be truncated.

8.2.2 Long Copying

Copy documents should be limited to the maximum length printed by the 6030/6050 printer. If
longer documents are used the printer may not print them correctly and may hang. Canceling a
long copy job may require a very long time to complete or may hang the system requiring it to be
rebooted.

8.2.3 Out of Toner reported as "printer needs attention"

When the 6030/6050 printer runs out of toner the error message presented in WebPMT is simply
"printer needs attention". The user needs to refer to the printer user interface to determine the
problem resolution required.

8.3 Scanner

8.3.1 Clear Last Image

When the "Clear Last Image" feature is selected on the Xerox Wide Format Scan System, it may
take a few minutes for a Photo or Color mode scanned document to clear out. After scanning a
document, this feature is accessed by selecting the "C" key on the scanner. It will bring up the
"CLEAR SCANNED IMAGE" screen. Use the "Next" button to select "CLEAR LAST IMAGE", and
then press "ENTER".

8.3.2 Invert Feature and Recall Last Job

Scan a document. Press the Transform key. Select "Recall Last Job". If the Invert feature
(changes dark to light and vice versa) is selected before printing the recalled document, the
document will not be inverted. It will need to be rescanned to get the inverted image.
Page 20
Long Plot Limit
3,000 mm
7,500 mm
15,000 mm