Xerox DocuColor 2240 Manuel de dépannage - Page 14

Parcourez en ligne ou téléchargez le pdf Manuel de dépannage pour {nom_de_la_catégorie} Xerox DocuColor 2240. Xerox DocuColor 2240 28 pages. Scan using ftp server
Également pour Xerox DocuColor 2240 : Manuel de connexion rapide (2 pages), Spécifications (2 pages), Notes de sécurité (15 pages), Manuel de démarrage rapide (4 pages), Manuel de démarrage rapide (4 pages), Manuel de démarrage rapide (6 pages), Manuel de l'utilisateur (36 pages), Manuel d'entretien (18 pages)

Imprimer la page
Xerox DocuColor 2240 Manuel de dépannage
U
G
( T
S E R
U I D E
R O U B L E S H O O T I N G

Stapler Faults

5 – 1 0
)
This section describes how to clear stapler faults. Follow the
procedures on the following pages when copies are not stapled or
when staples are bent.
NOTE:
To staple copies, the Finisher (optional accessory) must
be installed.
1
Make sure that the machine has stopped, then open the front
cover in the Finisher.
2
Hold the staple cartridge by its lever, and pull the staple cartridge
out to the right toward you.
3
Lift up the staple cartridge to remove it.
4
After removing the staple cartridge, check the inside of the
Finisher for any remaining staples.
5
Pull up the lever on the front of the staple cartridge.
6
Remove the jammed staples together with the staple sheet.
NOTE:
When removing jammed staples, also remove the staple
sheet. Do not remove unused staples from the staple cartridge.
CAUTION:
Be careful when removing jammed staples to avoid
hurting your fingers.
7
Close the lever on the front of the staple cartridge until you hear it
click into place.
8
Return the staple cartridge to its original position until you hear it
click into place.
9
Close the Finisher front cover.
NOTE:
A message will be displayed and the machine will not
operate if the Finisher front cover is not closed completely.