Xerox XEScan Manuel d'installation - Page 12

Parcourez en ligne ou téléchargez le pdf Manuel d'installation pour {nom_de_la_catégorie} Xerox XEScan. Xerox XEScan 21 pages.

6. Update the Firmware

This procedure updates the scanner firmware. New firmware is occasionally posted on the XES website

(http://www.XES.com) to correct problems and improve performance of the scanner.

1. Power on the scanner and observe the LED display (on the back of the scanner) for the completion of

the POST tests. After three minutes, a "P" or "E" will be displayed on the LED.

2. Power on the PC and observe the system for proper start up.

Note:

Verify that the LED on the rear of the scanner has a dot lit next to the displayed 'P' or 'E' after

Windows starts. The dot means the PC and scanner are communicating.

3. Download the latest version of firmware for the Synergix Scanner from the XES website.

4. Right mouse click on the Start button and select Explorer to open the Desktop Explorer.

5. Browse to the downloaded firmware file.

6. Double click on the firmware file.

Note: If the Firmware Update screen displays, go to Step 12. If not, continue with the following

steps.

7. Double-click on Synergix Diagnostics icon on the PC desktop.

8. Click on the Utilities button at the bottom of the screen. Wait for the Utilities screen to appear.

9. Click the Browse button below the Firmware Update entry field.

10. Browse to the downloaded firmware file location on your hard drive.

11. Click Open.

12. Click the Begin Firmware Update button on the screen. Diagnostics displays the Firmware Update

screen.

13. Click the Start button. The file downloads to the scanner.

14. When a new screen displays Please, power scanner OFF to enable new firmware, click OK.

Location of the LED

The Dot

must be

lit!

XEScan Solution Installation Guide